Chapter 2
Configuration
Configuration of the LZ520-2D Reader
The
When scanning setup bar codes (or just about any bar code for that matter) follow these tips for best results:
1)Since the
2)When more than one bar code is in the visible area of the scanner it is a good idea to cover the “unwanted” bar codes to prevent them from being read by acc ident.
3)If you scan a setup code by accident and the scanner is not working properly but you're not sure what you changed, it's best to scan the “Reset All Settings to Default” bar code and start over.
4)You will find that most bar codes read better when the scanner is angled slightly so that the light reflected from the bar code does not “blind” the scanner. It' s just like if you were to try to take a flash picture of a piece of paper, when you do it straight on the flash bounces back and you get a lot of glare but if you do it at a slight angle you get a nice picture.
5)Reading of
6)When reading a poor quality bar codes it is a good idea to put tighter limits on what the bar code reader
will allow to prevent errors in reading.
7) The
Warning: The setup codes in the