Panasonic CQ-VA7005W manual Front, Center, Sub W, Phase, ¡Sur

Page 34

English

33

Settings (continued)

(AUDIO continued)

SP SETUP (Speaker set up)

Setting the absence/presence and size of each speaker

FRONT

(Front speaker setting)

SMALL : for small speakers, or when bass playback is not possible

LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)

default: LARGE

CENTER

(Center speaker setting)

NONE : when not using a center speaker

SMALL : for small speakers, or when bass playback is not possible

LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)

default: NONE

*A center speaker (option, EAB-CF2 recommended) is required.

SUR

(Surround speaker setting)

NONE : when not using a surround speaker

SMALL : for small speakers, or when bass playback is not possible

LARGE : for large speakers, when bass playback is possible (at least 100 Hz or lower)

 

 

default:

LARGE

 

 

 

 

SUB - W

(Subwoofer speaker setting)

 

: when using a subwoofer

YES

 

: when not using a subwoofer

NO

default: NO

*A subwoofer (option, CJ-SW3003 recommended) is required. A power amplifier (option) is also required for connecting a subwoofer.

Note:

¡While the private mode is active, only FRONT can be adjusted.

PHASE

(Phase setting)

: subwoofer phase 0 degree

180° : subwoofer phase 180-degree inverted

Note:

¡This setting is feasible only when SUB-Wis set to YES .

default:

SP LEVEL (Speaker level)

Adjusting the output balance of each speaker

FRONT L

 

(Left front speaker output bal-

 

ance)

] : down,

[ : up

 

 

 

 

(Center speaker output bal-

CENTER

 

 

ance)

] : down,

[ : up

 

 

 

 

(Right front speaker output

FRONT R

 

 

balance)

] : down,

[ : up

 

 

 

 

(Right surround speaker out-

R¡SUR

 

 

put balance)

] : down,

[ : up

 

 

 

 

(Left surround speaker output

L¡SUR

 

 

balance)

] : down,

[ : up

 

 

 

 

(Subwoofer speaker output

SUB - W

 

 

balance)

] : down,

[ : up

 

Setting range: –10 dB to +10 dB (1 dB steps) default: ±0 dB for all speakers

¡If the speaker setting is NONE or NO for a speaker, the

test signal is not output and that speaker cannot be selected.

¡Turn rotary volume controller or press [+] or [–] (VOL) to adjust the volume of the test signal.

34

CQ-VD7005W

Image 34
Contents Model CQ-VD7005W Protect the Deck Mechanism Use the proper power supplyDo not use the unit when it is out of order Do not disassemble or modify the unitObserve the following cautions when using this unit Observe the following cautions when installingSafety Information Before Reading These Instructions ComponentsFeatures Contents Battery Replacement Other SettingsRemote Control Unit PreparationPictographs Symbols used in this manualDisc Marks Name of Controls and Functions SRC PWR RET RET ReturnMute + VOL ReturnDisplay Button Touch Panel Operation OverviewState of Operation Screen Source ButtonSource Switching the DisplayHow to Call up Operation Screen Standard Screen Operation ScreenGeneral Operations PowerGeneral OFFTilt Angle VolumeMute Folding DownDiscs that can be Played Back Before Disc PlaybackALL When a disc is in the player Disc Insert/EjectVideo Mode VCD Video CD mode displayDisc Mode DVD Selection Audio ModeBasic Operations Chapter/title Selection Audio Language Useful FunctionSubtitle Language AngleDisplayed items CommonDisplayable characters Maximum number of files/folders Copyright No warrantySupported file systems VBRTuning Radio Mode SelectionRadio Preset Memory Touch Source Button. d AV Mode SelectionAV1/AV2 on English User SettingsScreen Menu Operation Example setting screen of Display Unit aSelect/adjust MenuHow to cancel the known ID code How to set your ID code for the first timeHow to change your ID code DisplayIs selected BeepNo no memory clear Display returns to the previous one ProceedColor Adjusting level of each presetBright TintMixing SelectTruBass ¡TruBassCenter PhaseFront SURCenter ting Adjusting the output balance¡After setting the input level AV1 LevelSubtitle MenuAudio DR Comp PRO LogicDown MIX AV2 SkipSetting for AM stations Noise Suppression Noise suppression Received to prioritize sound qualityAspect Ratio ASP Pmode Private Mode¡Be sure to set to OFF when you do not use the private mode Press and hold ASP Pmode on the main unit forACheck the speaker wiring TroubleshootingCommon Again Check the wiring of the antenna power leadRadio ASecure the unit to the console box¡Refer to Notes on MP3/WMA a Disc has unplayable formatted dataThere is a flaw or foreign objects on the disc Disc is still unfinalizedDisplay does not go Back into the unit Display SettingsPicture is dark. No response to pressing ButtonsPlaying back a disc having a subwoofer channel Sound SettingsSpeaker setting ¡Pro Logic is set toCD/MP3/WMA/DVD/VCD Video CD Error Display MessagesCase you forget the ID code ID code memoMaintenance DVD-Rs/RWs Other cases... a Language Code ListCode Language Name Dts Dolby DigitalDolby Pro Logic Interactive DVDSpecifications YFM284C675CA PTW0107-1027 Installation Instructions ÀÌÒÚÛ͈Ëfl ÔÓ ÏÓÌÚ‡ÊÛ Safety Information Upgrade Options CQ-VD7005WInstallation Opening InstallationDashboard Installation Installation PrecautionsInstallation Hardware For WiringInstallation Hardware For Installation Transportation Bracket RemovalFastening the Mounting Collar Battery terminalMounting the Main Unit Insert Trim Plate qUsing the Rubber Cushion option Regular installation methodDeeper installation method Method for Fixing the Mounting SpringUse the supplied Spacer !1if mounting hole of your To Remove the UnitCar is shaped like below Side Brake Parking Brake Connection Lead Bright green Hand brakeFoot brake Side Brake Parking Brake Connection LeadElectrical Connections Speaker connectionsRadio Antenna Connector Radio ANT RGB ConnectorSystem-up Connector Pre-Out Connector frontCX-DH801W option DIN Cord Black DIN Connector Battery Lead YellowTo the car battery, continuous +12 V DC Connection with CD Changer CX-DP880CY-EM100N option Connecting the Reverse Lead Connection with Rear View CameraCamcorder option Connection with Rear MonitorConnection with VCR or Camcorder VCR optionCY-TUP133W 3Power ConnectorConnection with TV Tuner CY-TUN133W optionYFM294C099CA PTW0107-1027 System Upgrade Guidebook Safety Information Observe the following cautions when using this unit Rear Monitor System upgrade sampleTV Tuner Main Unit OptionConnectable devices Simultaneous Multi-Device Connection System-up ConnectorBluetooth technology Cellular PhoneCenter Speaker Channel Surround SystemFront Speakers CJ-DA1733 Surround Speakers CJ-DA6923 Source Selection Screen Menu Screen Menu Setting, a Operating InstructionsMenu Button DVD Changer *1 a TV tuner *1 aCD Changer a TV Mode Selection TV Tuner ControlCalling Deleting Preset Writing PresetPreset Channel BandTrack Selection CD Changer ControlDisc Selection Current DiscDVD Changer Mode Selection DVD Changer Control¡Reverse slow playback is not possible Chapter/title/track Selection¡Touch/press and hold in the pause Next discEnglish Bluetooth Hands-Free Mode Bluetooth Hands-Free KitCannot send calls Phone receiver AdjustmentAdjustment of Ring Back to PreviousTitle Scroll IPod Mode SelectionIPod Control Fast reverse Release to resume playbackStandard Screen Shuffle SongsShuffle Albums Operation ScreenCamera DVD INPUT/OUTPUT RadioConnection with Panasonic car navigation system Default Both When the Expansion Module CY-EM100N, option is disconnectedWhen the Expansion Module CY-EM100N, option is connected AV1Picture from a rear View camera is not Displayed ProblemIPod Control IPod is notNo magazine is in the changer IPod cable was disconnected in the iPod modeCD Changer/DVD Changer Control Your iPod has no playable musicYFM284C676CA PTW0107-2037