Panasonic CQ-VA7005W manual Observe the following cautions when using this unit

Page 3

Caution

Observe the following cautions when using this unit.

Keep the sound volume at an appropriate level.

Keep the volume level low enough to be aware of road and traffic conditions while driving.

Do not insert or allow your hand or fingers to be caught in the unit.

To prevent injury, do not get your hand or fingers caught in moving parts or in the disc slot. Especially watch out for infants.

This unit is designed for use exclusively in auto- mobiles.

Do not operate the unit for a prolonged period with the engine turned off.

Operating the audio system for a long period of time with the engine turned off will drain the battery.

Do not expose the unit to direct sunlight or exces- sive heat.

Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit.

Do not use the product where it will be exposed to water, moisture, or dust.

Exposure of the unit to water, moisture, or dust may lead to smoke, fire, or other damage to the unit. Make especially sure that the unit does not get wet in car washes or on rainy days.

Observe the following cautions when installing.

Refer wiring and installation to qualified service personnel.

Installation of this unit requires special skills and experi- ence. For maximum safety, have it installed by your dealer. Panasonic is not liable for any problems resulting from your own installation of the unit.

Follow the instructions to install and wire the prod- uct.

Not following the instructions to properly install and wire the product could cause an accident or fire.

Take care not to damage the leads.

When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.

Use the designated parts and tools for installation.

Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those supplied or designated may result in internal damage to the unit. Faulty installation may lead to an accident, a malfunc- tion or fire.

Do not block the air vent or the cooling plate of the unit.

Blocking these parts will cause the interior of the unit to overheat and will result in fire or other damage.

Do not install the product where it is exposed to strong vibrations or is unstable.

Avoid slanted or strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.

Installation Angle

The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚.

The user should bear in mind that in some areas there may be restrictions on how and where this unit must be installed. Consult your dealer for further details.

Wear gloves for safety. Make sure that wiring is completed before installation.

To prevent damage to the unit, do not connect the power connector until the whole wiring is complet- ed.

Do not connect more than one speaker to one set of speaker leads. (except for connecting to a tweeter)

Observe the following cautions when handling the battery for the remote control unit.

Use only specified battery (CR2025).

Match the polarity of the battery with the (+) and (–) marks in the battery case.

Replace a dead battery as soon as possible.

Remove the battery from the remote control unit when not using it for an extended period of time.

Insulate the battery (by placing them in a plastic bag or covering them with vinyl tape) before disposal or storage.

Dispose of the battery according to the local regulations.

Do not disassemble, recharge, heat or short the battery. Do not throw a battery into a fire or water.

In case of battery leakage

Thoroughly wipe the battery liquid off the battery case and insert new battery.

If any part of your body or clothing comes into contact with battery liquid, wash it with plenty of water.

If battery liquid comes into contact with your eyes, wash them with plenty of water and get immediate medical atten- tion.

English

2

CAUTION:

PLEASE FOLLOW THE LAWS AND REGULATIONS OF YOUR STATE, PROVINCE OR COUNTRY FOR WIRING, INSTALLATION, AND USE OF THIS UNIT AND THE DEVICES TO BE CONNECTED.

CQ-VD7005W

3

Image 3
Contents Model CQ-VD7005W Do not disassemble or modify the unit Use the proper power supplyDo not use the unit when it is out of order Protect the Deck MechanismObserve the following cautions when installing Observe the following cautions when using this unitSafety Information Components Before Reading These InstructionsFeatures Contents Preparation Other SettingsRemote Control Unit Battery ReplacementSymbols used in this manual PictographsDisc Marks Name of Controls and Functions Return RET ReturnMute + VOL SRC PWR RETSource Button Touch Panel Operation OverviewState of Operation Screen Display ButtonStandard Screen Operation Screen Switching the DisplayHow to Call up Operation Screen SourceOFF PowerGeneral General OperationsFolding Down VolumeMute Tilt AngleBefore Disc Playback Discs that can be Played BackALL Disc Insert/Eject When a disc is in the playerAudio Mode VCD Video CD mode displayDisc Mode DVD Selection Video ModeBasic Operations Chapter/title Selection Angle Useful FunctionSubtitle Language Audio LanguageCommon Displayed itemsDisplayable characters VBR Copyright No warrantySupported file systems Maximum number of files/foldersRadio Mode Selection TuningRadio Preset Memory AV Mode Selection Touch Source Button. dAV1/AV2 on English Settings UserScreen Menu Example setting screen of Display Unit aSelect/adjust Menu OperationDisplay How to set your ID code for the first timeHow to change your ID code How to cancel the known ID codeProceed BeepNo no memory clear Display returns to the previous one Is selectedTint Adjusting level of each presetBright Color¡TruBass SelectTruBass MixingSUR PhaseFront CenterAV1 Level Adjusting the output balance¡After setting the input level Center tingMenu SubtitleAudio AV2 Skip PRO LogicDown MIX DR CompReceived to prioritize sound quality Setting for AM stations Noise Suppression Noise suppressionAspect Ratio Press and hold ASP Pmode on the main unit for Private Mode¡Be sure to set to OFF when you do not use the private mode ASP PmodeTroubleshooting ACheck the speaker wiringCommon ASecure the unit to the console box Check the wiring of the antenna power leadRadio AgainDisc is still unfinalized Disc has unplayable formatted dataThere is a flaw or foreign objects on the disc ¡Refer to Notes on MP3/WMA aNo response to pressing Buttons Display SettingsPicture is dark. Display does not go Back into the unit¡Pro Logic is set to Sound SettingsSpeaker setting Playing back a disc having a subwoofer channelID code memo Error Display MessagesCase you forget the ID code CD/MP3/WMA/DVD/VCD Video CDMaintenance DVD-Rs/RWs Language Code List Other cases... aCode Language Name Interactive DVD Dolby DigitalDolby Pro Logic DtsSpecifications YFM284C675CA PTW0107-1027 Installation Instructions ÀÌÒÚÛ͈Ëfl ÔÓ ÏÓÌÚ‡ÊÛ Safety Information CQ-VD7005W Upgrade OptionsInstallation Precautions InstallationDashboard Installation Installation OpeningTransportation Bracket Removal For WiringInstallation Hardware For Installation Installation HardwareInsert Trim Plate q Battery terminalMounting the Main Unit Fastening the Mounting CollarMethod for Fixing the Mounting Spring Regular installation methodDeeper installation method Using the Rubber Cushion optionTo Remove the Unit Use the supplied Spacer !1if mounting hole of yourCar is shaped like below Side Brake Parking Brake Connection Lead Hand brakeFoot brake Side Brake Parking Brake Connection Lead Bright greenSpeaker connections Electrical ConnectionsPre-Out Connector front RGB ConnectorSystem-up Connector Radio Antenna Connector Radio ANTCX-DH801W option Connection with CD Changer CX-DP880 Battery Lead YellowTo the car battery, continuous +12 V DC DIN Cord Black DIN ConnectorCY-EM100N option Connection with Rear View Camera Connecting the Reverse LeadVCR option Connection with Rear MonitorConnection with VCR or Camcorder Camcorder optionCY-TUN133W option 3Power ConnectorConnection with TV Tuner CY-TUP133WYFM294C099CA PTW0107-1027 System Upgrade Guidebook Safety Information Observe the following cautions when using this unit Option System upgrade sampleTV Tuner Main Unit Rear MonitorConnectable devices Cellular Phone System-up ConnectorBluetooth technology Simultaneous Multi-Device ConnectionChannel Surround System Center SpeakerFront Speakers CJ-DA1733 Surround Speakers CJ-DA6923 Menu Setting, a Operating Instructions Source Selection Screen Menu ScreenMenu Button TV tuner *1 a DVD Changer *1 aCD Changer a TV Tuner Control TV Mode SelectionBand Writing PresetPreset Channel Calling Deleting PresetCurrent Disc CD Changer ControlDisc Selection Track SelectionDVD Changer Control DVD Changer Mode SelectionNext disc Chapter/title/track Selection¡Touch/press and hold in the pause ¡Reverse slow playback is not possibleEnglish Bluetooth Hands-Free Kit Bluetooth Hands-Free ModeCannot send calls Back to Previous AdjustmentAdjustment of Ring Phone receiverFast reverse Release to resume playback IPod Mode SelectionIPod Control Title ScrollOperation Screen Shuffle SongsShuffle Albums Standard ScreenDVD INPUT/OUTPUT Radio CameraConnection with Panasonic car navigation system AV1 When the Expansion Module CY-EM100N, option is disconnectedWhen the Expansion Module CY-EM100N, option is connected Default BothIPod is not ProblemIPod Control Picture from a rear View camera is not DisplayedYour iPod has no playable music IPod cable was disconnected in the iPod modeCD Changer/DVD Changer Control No magazine is in the changerYFM284C676CA PTW0107-2037