Panasonic TQBJ0302 manual Projector Setup menuPROJECTOR Setup menu

PROJECTOR SETUP menuPROJECTOR SETUP menu

Navigating through the MENU (Æpage 27), select

PROJECTOR SETUP from the main menu and then select the required item from the sub-menu.

zzSet the selected item with◄►buttons.

Remote control Control panel

STATUS

You can check the using status of the projector.

JJSIGNAL

zzNAME: Name of input signal

zzFREQUENCY: Scanning frequency of input signal

JJRUNTIME

zzPROJECTOR: Display current usage time of projector

zzLAMP: Display current usage time of lamp

NO SIGNAL SHUT-OFF

If no image signal is input for the time set with the timer, the projector will enter into standby mode automatically.

Change setting Change setting

DISABLE	NO SIGNAL SHUT-OFF is disabled
15 - 60 MIN.	Timer can be set in intervals of 5
	minutes

INITIAL START UP

You can set the starting method when the power plug is connected to wall outlet.

Change setting Change setting

LAST MEMORY	Projector starts from the last image
	before the power plug was
	disconnected
STANDBY	Projector starts in the standby
	mode
ON	Projector starts immediately

INSTALLATION

When installing the projector, select the projection method according to the projector position. (Æpage 16)

Change setting Change setting

FRONT/	Setting on a desk/floor and
DESK	projecting from front
FRONT/	Mounting in the ceiling with a ceiling
	mount bracket (sold separately) and
CEILING
	projecting from front
REAR/DESK	Setting on a desk/floor and projecting
	from rear (Translucent screen is
	required)
	Mounting in the ceiling with a ceiling
REAR/CEILING	mount bracket (sold separately) and
	projecting from rear (Translucent
	screen is required)

HIGH ALTITUDE MODE

If you use the projector at high elevation, the HIGH ALTITUDE MODE setting need to be ON to set the fan speed high.

Change setting Change setting

OFF	For use in normal environment
ON	For use at high altitude

Remarks

zzAt 1 400 -2 700 m (4 593 - 8 858 ft) sea level, the setting must be ON.

zzThe loudness of fan noise depends on the HIGH ALTITUDE MODE setting.

Settings

ENGLISH - 39