Zebra Technologies Strata Thermal Printers manual Ribbons, Communications Interface

Page 59

Printer Features

Media • Type: roll-fed, die-cut, continuous or fan- fold labels, tags or tickets

•Materials: thermal transfer or thermal sensi- tive papers

•Maximum media width: 8.75" (222.3mm)

•Minimum media width: 4" (102mm)

•Maximum media length: 11" (279mm) stan- dard, 22" (559mm) optional with maximum print width set. Note: The actual print length is dependent upon the programmed print (image) width and the maximum length will increase as the print area is narrowed.

•Minimum media length: .5" (12.7mm)

With optional cutter: 1.25” (31.75mm)

•Media thickness (w/ liner): .003" (.08mm) to

.0075" (.19mm)

•Internal supply roll capacity: 5" (127mm) O.D.

Ribbons

Communications Interface

•Wax, Wax/Resin and Resin

•Standard widths: 4.33" (110mm), 5" (127mm), 6" (152mm), 6.5" (165mm), 7" (178mm) and 8.66" (220mm)

•Standard length: 6.142" (156m), on a 1" (25mm) I.D. Core

•RS232C

•Centronics parallel

•Xon/Xoff, hardware handshaking

•Programmable 7 or 8 bit data length, 1 or 2 stop bits, selectable parity

•4,800 to 38,400 baud rates

980181-001 Rev.C

51

Image 59

Contents Strata Page Foreword We Need To Hear From You Return Materials AuthorizationTable of Contents General Cautions and Warnings Media Cautions & Tips Viii Installation Check List 1 Printer = Off Step ➊ Attach PowerCheck Voltage Parallel Interface Serial Interface Step ➋ Attach Interface Cable= On Step ➌ Apply PowerSoftware Operation Your Printer Ribbon Take-up Spindle Sensor Guide Bar Bracket Operation Operation Status Indicator Loading Labels or Tags Correct Incorrect Operation Operation Media Guides Release Lever Operation Operation Move the media roll to the lower media stand for printing Sensor Position Adjustment Wheel Sensor Position MarkerStep Operation Windows Users Loading Transfer Ribbons Take-Up Spindles Supply Tracking BarNotch Long Spoke Notch Operation Operation Operation Removing a Partially Used Transfer Ribbon Top Of Form Sensing Dump Mode Sample Printout Operation Operation Cleaning the Print Head Sensor Bracket Cleaning UnderUsing the Label Dispenser Remove slack by pulling the liner Operation Appendix a Troubleshooting Common Printing Problems Troubleshooting Guide Check for Out-of-Media condition or missing Internet Serial Interface Cable Wiring Serial Interface Communication ConfigurationDirection Tag Media SensingPrint Appendix B Printer Features Hardware Options Accessories General Specifications Software and Drivers Bar Codes CodePostnet Communications Interface RibbonsPrinter Features Appendix C Supplies and Accessories Thermal Retail applications where labels are 980181-001 Rev.C Appendix D Using the Media Cutter Specifications Cutter warranty Using the Media Cutter Use tweezers to remove media from the internal blade areas Clear the JamReplace the Cutter Check the Cutter Zebra Technologies Corporation Eltron Products World Wide Offices