Zebra Technologies 2844 Printer user manual Load Media

Page 11

Installation and Operation

Load Media - continued

Remove the outside length of media

MOVIE

For more infor- mation on media preparation, refer to Appendix A.

Install Roll

Note: Find the instructions for preparing media in Appendix A.

Close Guides to the Width of the Media

Note: When using linerfree labels, adjust the guides to the widest position

980348-001 Rev. A

7

Image 11

Contents Thermal Printer User’s Manual 2844 Foreword Shock Hazard Warning Table of Contents Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Step ➌ Load Media Load Media Release Cover Step ➍ AutoSense Media Gap Sensing AutoSense Gap Sensor Adjustment Step ➎ Install Software Thermal Printing Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Step ➌ Install Take-Up Core Attach Ribbon to Take-Up Core Remove Slack From Ribbon Step ➍ Tighten RibbonReplacing a Partially Used Transfer Ribbon Adding a New Transfer RibbonUsing the Label Dispenser Using Fan-Fold Media Using the Media Cutter 980348-001 Rev. a Problem Solution or Reason Appendix a TroubleshootingRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable Bus USB For the cable connectorsTurn OFF O the printer before performing this procedure Cleaning the Platen Tag Stock Rolls Find the tape and detach the bottom tag Preparing Media Paper, and Labels Before Loading980348- 001 a