Zebra Technologies 2844 Printer user manual Step ➊ Attach Power Supply To The Printer

Page 8

Installation and Operation

Installation The following steps will guide you through the installation of the printer and software.

Step ➊ Attach Power Supply To The Printer

Power OFF

Check Voltage

Plug in

Power

Module

Plug in

Power

Cord

Plug Power Cord

into a Suitable

AC Outlet

See the SHOCK HAZARD WARNING on page iv.

4	980348-001 Rev. A

Image 8

Contents Thermal Printer User’s Manual 2844 Foreword Shock Hazard Warning Table of Contents Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Step ➌ Load Media Load Media Release Cover Step ➍ AutoSense Media Gap Sensing AutoSense Gap Sensor Adjustment Step ➎ Install Software Thermal Printing Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Step ➌ Install Take-Up Core Step ➍ Tighten Ribbon Attach Ribbon to Take-Up Core Remove Slack From RibbonAdding a New Transfer Ribbon Replacing a Partially Used Transfer RibbonUsing the Label Dispenser Using Fan-Fold Media Using the Media Cutter 980348-001 Rev. a Appendix a Troubleshooting Problem Solution or ReasonRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable For the cable connectors Bus USBTurn OFF O the printer before performing this procedure Cleaning the Platen Preparing Media Paper, and Labels Before Loading Tag Stock Rolls Find the tape and detach the bottom tag980348- 001 a