Zebra Technologies 2844 Printer user manual 980348-001 Rev. a

Page 26

Clearing the If the blade cuts through labels, adhesive can Media Cutter jam the cutter.

Turn OFF (O) printer power and unplug the power and interface cables before clearing the cutter.

Keep the cutter dry. Never use any solutions or solvents to clean the blade.

After removing debris, plug in the power and interface cables, turn on the printer, then test for normal operation.

22	980348-001 Rev. A

Image 26

Contents Thermal Printer User’s Manual 2844 Foreword Shock Hazard Warning Table of Contents Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Step ➌ Load Media Load Media Release Cover Step ➍ AutoSense Media Gap Sensing AutoSense Gap Sensor Adjustment Step ➎ Install Software Thermal Printing Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Step ➌ Install Take-Up Core Step ➍ Tighten Ribbon Attach Ribbon to Take-Up Core Remove Slack From RibbonAdding a New Transfer Ribbon Replacing a Partially Used Transfer RibbonUsing the Label Dispenser Using Fan-Fold Media Using the Media Cutter 980348-001 Rev. a Appendix a Troubleshooting Problem Solution or ReasonRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable For the cable connectors Bus USBTurn OFF O the printer before performing this procedure Cleaning the Platen Preparing Media Paper, and Labels Before Loading Tag Stock Rolls Find the tape and detach the bottom tag980348- 001 a