Zebra Technologies 2844 Printer user manual Release Cover

Page 12

Installation and Operation

Load Media - continued

Release Cover

MOVIE

Note: This step applies to thermal transfer printers

Close Cover

8	980348-001 Rev. A

Image 12

Contents Thermal Printer User’s Manual 2844 Foreword Shock Hazard Warning Table of Contents Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Step ➌ Load Media Load Media Release Cover Step ➍ AutoSense Media Gap Sensing AutoSense Gap Sensor Adjustment Step ➎ Install Software Thermal Printing Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Step ➌ Install Take-Up Core Step ➍ Tighten Ribbon Attach Ribbon to Take-Up Core Remove Slack From RibbonAdding a New Transfer Ribbon Replacing a Partially Used Transfer RibbonUsing the Label Dispenser Using Fan-Fold Media Using the Media Cutter 980348-001 Rev. a Appendix a Troubleshooting Problem Solution or ReasonRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable For the cable connectors Bus USBTurn OFF O the printer before performing this procedure Cleaning the Platen Preparing Media Paper, and Labels Before Loading Tag Stock Rolls Find the tape and detach the bottom tag980348- 001 a