Zebra Technologies 2844 Printer user manual Step ➍ Tighten Ribbon

Page 21

Using Options

Step Tighten Ribbon

Attach Ribbon to

Take-Up Core

Note: Use the adhesive strip on new rolls; otherwise, use tape

Remove Slack

From Ribbon

When using ribbon, make sure you also use thermal transfer media.

980348-001 Rev. A

17

Image 21
Contents Thermal Printer User’s Manual 2844 Foreword Shock Hazard Warning Table of Contents Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Step ➌ Load Media Load Media Release Cover Step ➍ AutoSense Media Gap Sensing AutoSense Gap Sensor Adjustment Step ➎ Install Software Thermal Printing Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Step ➌ Install Take-Up Core Attach Ribbon to Take-Up Core Remove Slack From Ribbon Step ➍ Tighten RibbonReplacing a Partially Used Transfer Ribbon Adding a New Transfer RibbonUsing the Label Dispenser Using Fan-Fold Media Using the Media Cutter 980348-001 Rev. a Problem Solution or Reason Appendix a TroubleshootingRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable Bus USB For the cable connectorsTurn OFF O the printer before performing this procedure Cleaning the Platen Tag Stock Rolls Find the tape and detach the bottom tag Preparing Media Paper, and Labels Before Loading980348- 001 a