Zebra Technologies 2844 Printer user manual Using the Label Dispenser

Page 23

Using Options

Using the Label Dispenser

Open

Door

MOVIE

Switch On

the Label

Taken Sensor

Remove

Several

Labels

Push

Liner

Through

Slot

Close

Door

Close

Top Cover

and Press

Feed Button

980348-001 Rev. A

19

Image 23

Contents Thermal Printer User’s Manual 2844 Foreword Shock Hazard Warning Table of Contents Installation and Operation Unpack Your Printer Know Your Printer Installation and Operation Step ➊ Attach Power Supply To The Printer Step ➋ Attach Interface Cable Step ➌ Load Media Load Media Release Cover Step ➍ AutoSense Media Gap Sensing AutoSense Gap Sensor Adjustment Step ➎ Install Software Thermal Printing Direct or Transfer? Using Options Step ➊ Prepare Ribbon Step ➋ Install Supply Roll Step ➌ Install Take-Up Core Attach Ribbon to Take-Up Core Remove Slack From Ribbon Step ➍ Tighten RibbonReplacing a Partially Used Transfer Ribbon Adding a New Transfer RibbonUsing the Label Dispenser Using Fan-Fold Media Using the Media Cutter 980348-001 Rev. a Problem Solution or Reason Appendix a TroubleshootingRED Troubleshooting Media Handling Host Female DB-25 to Male Centronics Cable Bus USB For the cable connectorsTurn OFF O the printer before performing this procedure Cleaning the Platen Tag Stock Rolls Find the tape and detach the bottom tag Preparing Media Paper, and Labels Before Loading980348- 001 a