Nortel Networks 5000BH manual Connecting Cables to TokenSpeed Ports, Seating the module

Installing and Connecting the TokenSpeed Module

5.To seat the module against the backplane, rotate the inserter/extractor levers inward toward each other (see Figure 3-5).

6537

Figure 3-5. Seating the module

When the front panel of the module is flush with the front of the chassis, the module backplane connectors are properly seated.

6.Align and tighten the captive retaining screw at each end of the module front panel (see Figure 3-5).

Connecting Cables to TokenSpeed Ports

This section describes how to connect cables to the ports on a TokenSpeed module with the following connections:

•Token ring connections to the RJ-45 ports

•Management connection to the MCP port

893-01019-A 3-5