B&B Electronics MAP450D installation manual Benchtop Mount, Mounting Plate

16	MAP450D
	5.400 +/-0.015
	2 places
	0.156 dia. nominal,
	4 holes(clearance
	for #6 screws)

	PEDESTAL
4.600 +/-0.015	MOUNTING
	PLATE	5.00 nominal
2 places
	(1/8" thick min. recommended)

6.00 nominal

Figure 11 Pedestal/Pendant Mounting Plate Dimensions

The OIT is connected to the mounting plate with four #6-32UNC screws. The length of the mounting screws is equal to the plate thickness plus 1/4 inch.

NOTE: The mounting screws must not be torqued to more than 18 pound-inches. Over-torquing can strip the threads in the enclosure.

3.3. Benchtop Mount

The MAP450D’s rear cover has two legs set at a five degree angle to give the display and keypad a sloped front while sitting on a bench. Four rubber feet are attached to the legs to prevent slippage as well as damage to the surface of the bench.

Figure 12 MAP450D Benchtop Mounting

1010-0046A, REV 00