B&B Electronics MAP450D installation manual Appendix a OIT Hardware Specifications, Mechanical

Page 18

18

MAP450D

Appendix A

OIT Hardware Specifications

Mechanical

Material: Cast aluminum enclosure sealed to NEMA 4/12

Mounting: Panel, pedestal, pendant, or benchtop

Wiring: Unit is field-wired by user to internal terminal block pins

Weight: 2 pounds (0.90 kg)

Environmental

Operating Temp: +32 to +122°F (0 to +50°C)

Storage Temp: -4 to +158°F (-20 to +70°C)

Electric Noise Immunity

Emissions:

EN55011 (Group 1, Class B) — Generic commercial, light, and heavy industrial environments

 

EN50081-1

— Generic domestic and light industrial environments

 

EN50081-2

— Generic heavy industrial environment

Immunity:

EN50082-1

— Generic domestic and light industrial environments

 

EN50082-2

— Generic heavy industrial environment

Power Requirements

Input Voltage: 12 to 30 VDC

Power Usage: 2.5 watts typical

Display

Display Type (MAP450D-003): Liquid Crystal Display (LCD)—5 x 7 dot matrix with cursor

Display Type (MAP450D-004): Backlit Liquid Crystal Display (LCD)—5 x 7 dot matrix with cursor

Display Character Size: 2 lines by 40 characters, 0.2 inches (5 mm) high

Display Viewing Angle: Approximately 120 degrees

Keypad

Key Type: Membrane switch

Feedback: Internal buzzer

Layout: 42 alphanumeric keys arranged in 4 rows of 11 keys

Operational Life: Five million operations, minimum

Customizing: Custom keypad overlay available

Communications

Serial Port: RS-232, RS-422, or RS-485

Baud Rates: 300, 600, 1200, 2400, 4800, 9600, or 19.2k

Internal Features

Memory: 128K x 8 Flash PROM for firmware, protocol and configuration data—no battery required

1010-0046A, REV 00

Image 18
Contents Installation Manual Applications Assistance Static Awareness Read Me FirstIntroduction Unpacking the UnitTable of Contents Power Supply Selection Control Panel Design GuidelinesControl Panel Grounding OIT Cable Routing Other Steps to Improve Noise ImmunityConnecting the MAP450D to a Host Controller Host/ControllerFerrite coil RS-232 Interactive & Block modes RS-422/485 Interactive & Block modesRS-422/485 Network mode OITOIT #2 Network Termination Set Jumper for 3-Wire RS-422/485 Cable shield must not be used as the signal groundMounting the MAP450D Panel MountPedestal/Pendent Mount MAP450D Pedestal MountingBenchtop Mount Mounting PlateConfiguring the MAP450D Connecting the MAP450D to a PCAppendix a OIT Hardware Specifications MechanicalAppendix a con’t Dimensional Outline Front View Rear ViewAppendix B Differences Between MAP450D and MAP450B