Installation Considerations

This section focuses on some of the vehicle consider- ations for installing your new Punch amplifier. Checking your battery and current sound system, as well as pre- planning your system layout and best wiring routes will save installation time. When deciding how to lay out your new system, be sure that each component will be easily accessible for making adjustments.

Before beginning any installation, be sure to follow these simple rules:

1.Carefully read and understand the instructions before attempting to install the amplifier.

2.For easier assembly, we suggest you run all wires prior to mounting your amplifier in place.

3.Use only quality connectors for making connections. See your Authorized Rockford Fosgate Dealer for Perfect Interface wire enhancements.

4.Think before you drill! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.

5.For safety, disconnect the battery ground cable prior to connection of the amplifier.

6.Never run wires underneath the vehicle. The cleanest, safest wiring connections are made by running the wire under the carpet or behind the side panels. Never leave wires exposed.

7.Avoid running wires over or through sharp edges. Use grommets to protect wires routed through holes in metal.

8.ALWAYS protect the battery and electrical system from shorts with proper fusing. A fuse holder and fuse must be installed within 18” (45.72cm) of the battery terminal to safeguard from possible damage or injury.

9.When grounding scrape paint off metal to ensure a good, clean ground connection. Grounding connec- tions should be as short as possible and always be