MGE UPS Systems 2200 RT 2U, EXB RT 3U, 2200 RT 3U Installation, Unpacking and contents check

Page 8

2. Installation

2.1 Unpacking and contents check

32

31

30

33

34

35

36

37

39

38

41

40

	42			43
				43
	ETHERNET	Settings/Sensor
				44
	100M 10M	UPS data RS232
	On = Link	66102
	Blink = Act	66102
(30)	Pulsar M 2200 or 3000 UPS		Elements supplied depending on the version or optional
(31) connection cable to AC-power source			(38)	Mounting kit for 19-inch bays
(32)	2 connection cables for the protected equipment		(39)	2 supports for the upright position (2U version only)
(33)	RS232 communications cable		(40)	FlexPDU module (optional)
(34)	USB communications cable		(41) connection cable between FlexPDU module and UPS
(35)	2 systems to secure power plugs		(42)	NMC communication card (optional)
(36)	Solution-Pac CD-ROM		(43)	HotSwap MBP module (optional)
(37) Documentation			(44) connection cables between HotSwap MBP module and
			UPS

Packing materials must be disposed of in compliance with all local regulations concerning waste.

Recycling symbols are printed on the packing materials to facilitate sorting.

34007776EN/AB - Page 8

Image 8

Contents Pulsar M 34007776EN/AB Introduction Environmental protectionSubstances PackingPictograms Contents Dimensions H x W x D in mm Weights in kgPresentation Standard positionsPulsar M EXB optional battery module Rear panelsControl panel Pulsar M 2200Installation Unpacking and contents checkInstallation in tower position Installation in rack position Connection of RS232 or USB communication port optional Installation of the communication cards optionalCommunication ports Connections with a HotSwap MBP module optional FlexPDU moduleUPS connection without a FlexPDU or HotSwap MBP module HotSwap MBP-module operationUPS start-up with the HotSwap MBP module HotSwap MBP-module testStart-up and normal operation Operation on battery powerOperation Return of AC power Using the UPS remote control functionsEnd of battery backup time Remote control connection and testROO RPO Access to measurements and personalisation data Access to measurementsPersonalisation using the control panel Display menus arrangementPersonalisation using external software Battery personalisationOutput personalisation ON/OFF personalisationIndication Diagnostic Correction MaintenanceTroubleshooting Battery-module replacement Troubleshooting a UPS equipped with the HotSwap MBP moduleSafety recommendations Battery-module removalMaintenance on a UPS equipped with the HotSwap MBP module Mounting the new battery moduleMaintenance Return to normal operationTraining centre Hz training centreMGE UPS Systems FranceTechnical specifications AppendicesGlossary 34007776EN/AB