Output personalisation

Function	Factory setting	Other available settings	Comments

Output voltage (1)	230 Volts AC	200/208/220/240 Volts AC

Frequency converter (1)	Disabled	Enabled	The connected devices are never
			transferred to the bypass.

Output frequency (1)	Automatic selection	50 or 60 Hz	User selectable only if the
			frequency-converter function is
			enabled.

Transfer to the bypass AC	Bypass AC power must	Bypass AC power may be
input (1)	be within tolerances	outside tolerances

Overload level (1)	102%	50 / 70%	Alarm if threshold is overrun.

(1)These parameters may be modified only when the UPS is OFF. Detailed comments are available in the Personal Solution-Pacsoftware.

ON/OFF personalisation

Function	Factory setting	Other available settings	Comments

Start on battery power	Enabled	Disabled

Automatic restart	Enabled	Disabled	The UPS restarts automatically when
			AC power returns.

Energy savings	Disabled	Enabled	When function enabled, battery shuts
			down when power drops to <5%.

Detection of phase/	Disabled	Enabled	When function enabled, the UPS
neutral inversion (SWF)			remains OFF if the system detects
			phase/neutral inversion.

Function	Factory setting	Other available settings	Comments

Battery test	Weekly test	No test / daily test /
		monthly test

Low-battery warning	20%	0 to 100%	Adjustable in 1% steps.

Selection of the backup	Automatic detection of	65 to 400 Ah
time	number of battery
	modules

Battery protection against	Enabled	Disabled	When function disabled, MGE UPS
excessive discharges			SYSTEMS warranty no longer
			applies.

◗Insert the Solution-PacCD-ROM in the drive.

◗On the first navigation screen, select "Point to Point solution" and follow the instructions on how to install the Personal Solution-Pacsoftware.

◗Then select "Settings", "Advanced settings" and "UPS settings".

Note that the Linux/Unix/MacOS versions of the Personal Solution-Pacsoftware do not offer this possibility.