MGE UPS Systems GES-102L, GES-202L, GES-152L, GES-302L Site Wiring Fault Indicators RED LED

Page 9

Always “On” UPS Systems Inc.

16. INPUT CIRCUIT BREAKER

It trips when the connected loads exceed the protected receptacle's capacity. The center plungers of the circuit breakers extend when tripped.

17. SITE WIRING FAULT INDICATORS (RED LED)

It illuminates when the UPS is connected to an improperly wired AC power outlet.

Note: This device is available on 120 VAC model only.

18. COMPUTER INTERFACE

Provides both RS-232 and relay signal to support NOVELL, UNIX, DOS, WINDOWS and other operating systems.

9

Image 9
Contents Uninterruptible Power Supply Always On UPS Systems Inc Always On UPS Systems Inc Battery Replacement Troubleshooting Storage Introduction 36VDC Safety InstructionsFront Panel PresentationTELEPHONE/MODEM/ETHERNET Surge Protection Rear PanelSite Wiring Fault Indicators RED LED Installation Check the Site Wiring Fault Indicator Connecting the Telephone/Modem/Ethernet LinesOperation Audible Alarm Software Options UPSilon 2000 SoftwareInterface Kits Computer Interface Port Open Collector Dry Contact CommunicationRS-232 Communication Remove watches, rings, etc Use tools with insulated handles Battery ReplacementTroubleshooting Problems Possible causesSolution Storage Storage ConditionsExtended Storage Black RED Battery Bank InstallationSpecification SpecificationsGES-801LR GES-102LR GES-152LR GES-202LR GES-302LR Additional Purchases or Upgrades QA / Warranty QuestionsSoftware Questions