MGE UPS Systems GES-152L, GES-202L, GES-302L Connecting the Telephone/Modem/Ethernet Lines

Always “On” UPS Systems Inc.

Connecting the Telephone/Modem/Ethernet Lines

Connect a telephone line, modem line, or 10BaseT line into the telephone/modem/Ethernet surge protection sockets on the back of the UPS. The RJ-45/RJ-11 modular sockets accept standard single line telephone connections and 10BaseT connectors. This connection will require another length cable.

Note: This connection is optional. It is not necessary to use this with the UPS.

Caution: The line current limiting feature could be rendered inoperable if improperly installed. Make sure that the line from the wall is plugged into the connector marked “IN”, and the device to be protected (telephone, modem, etc.) is plugged into the connector marked “OUT”.

Caution: This surge protection device is for indoor use only, never install wiring during a lightning storm.

Check the Site Wiring Fault Indicator

After plugging in the load(s) and the UPS, check the site wiring fault indicator on the rear panel. It lights up if the UPS is plugged into an improperly wired AC power outlet. Wiring faults detected include ground, hot-neutral polarity reversal, and overloaded neutral circuit.

11