American Power Conversion AP7922 quick start Quick Configuration

Page 13

Quick Configuration

BOOTP. You can use an RFC951-compliant BOOTP server to configure the TCP/IP settings for the Rack PDU. If the BOOTP server is properly configured, the Rack PDU’s default setting (DHCP & BOOTP) for BOOT Mode causes it to discover the BOOTP server.

If a BOOTP server is unavailable, see “APC Management Card Wizard” on page 8, “Local access to the control console” on page 11, or “Remote access to the control console” on page 11 to configure TCP/IP settings.

1. Enter the Rack PDU’s MAC and IP addresses, the subnet mask and default gateway settings, and an optional bootup file name in the BOOTPTAB file of the BOOTP server.

The MAC address is on the bottom of the Rack PDU and on the Quality Assurance slip included in the package.

Note

2.When the Rack PDU reboots, the BOOTP server provides it with the TCP/IP settings.

If you specified a bootup file name, the Rack PDU attempts to transfer that file from the BOOTP server using TFTP or FTP. The Rack PDU assumes all settings specified in the bootup file.

If you did not specify a bootup file name, the Rack PDU can be configured remotely by using Telnet or by using the Web interface: user name and password are both apc, by default. See “Remote access to the control console” on page 11 for configuration instruction.

You must use the APC Management Card Wizard to create the bootup file. To create a bootup file, see the

See also BOOTP section in the Addendum.

Switched Rack PDU Installation and Quick Start

9

Image 13
Contents Switched Rack Power Distribution Unit Page Contents Specifications AP7922 Product Description and InventoryDocumentation AdditionalInventory Receiving inspectionHow to Install the Rack PDU Mounting options How to Install the Rack PDU Display interface OperationTCP/IP configuration methods Quick ConfigurationOverview Bootp the default setting ConfigurationQuick Configuration Option 43 = 01 04 31 41 50 43 where Remote access to Local access toControl console Use apc for both user name and password Use Telnet to access the Rack PDU at its newly assigned IPControl console on page 11 or Remote access to the control If you are not using a Bootp or Dhcp server to configureWeb interface Telnet/SSH Transfers using FTP compromises the high security If you enable SSL and SSH, disable FTP. Allowing fileEnvironment of SSL and SSH. Administrators can disable How to Recover From a Lost Password Xmodem How to Download Firmware UpdatesElectrical SpecificationsLimited warranty Warranty and ServiceWarranty limitations Obtaining serviceGeneral policy Life-Support PolicyExamples of life-support DevicesResponsibility for correcting such interference Radio Frequency InterferenceCanada-ICES Japan-VCCIAPC Worldwide Customer Support