American Power Conversion SURTA1500XLJ   Connect the Battery and Install the Front Bezel

Page 4

Installation

The EPO feature provides immediate de-energizing of the UPS and connected equipment from a remote location, without switching to battery operation.

1.Use one of the following cable types to connect the UPS to the EPO switch.

–CL2: Class 2 cable for general use.

–CL2P: Plenum cable for use in ducts, plenums, and other spaces used for environmental air.

–CL2R: Riser cable for use in a vertical run in a floor-to-floor shaft.

–CLEX: Limited use cable for use in dwellings and for use in raceways.

–For installation in Canada: Use only CSA certified, type ELC (extra-low voltage control cable).

–For installation in other countries: Use standard low-voltage cable in accordance with national and local regulations.

2.Locate the EPO connector on the rear of the UPS. Use a normally-open contact to connect cable to each EPO terminal .

Connect the Battery and Install the Front Bezel

The battery is shipped in the disconnect position. Do not connect the battery until you are ready to use the equipment.

1.Remove the battery cover .

2.Remove the warning label and protective sticker from the battery connector. Place the sticker on the back of the battery cover for re-use.

3.Snap the battery connectors together .

4.Reinstall the battery cover .

5.Install the front bezel .

4 Smart-UPS RT SURTA1500XL/SURTA1500XLJ/SURTA2000XL Uninterruptible Power Supply User Manual

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Introduction/Before Installation Contact Information Safety InformationUnpacking and Equipment Placement About this ManualInstallation To Install the UPS in a RackTo Install the UPS as a Tower Configuration To Install the UPS with External Battery PacksConnectors Type Description If Required, Connect the Emergency Power Off EPO Feature  Connect the Battery and Install the Front Bezel Connect Power and Start Up the UPS Terminal Mode ConfigurationFor Additional Computer System Security Operation Display Panel IndicatorsDisplay Panel On Battery Operation LEDConfiguration Settings Utility Voltage MeasurementFunction Factory Default User Selectable Description Choices Storage, Maintenance, Transport, and Service To Install a Replacement BatteryStorage Transporting the UPS to Another LocationBattery Replacement Instructions ServiceTroubleshooting Problem and/or Possible Cause SolutionEquipment There is no utility power Radio Frequency Warning Regulatory ApprovalsCopyright Notice Limited Warranty990-1856A 06/2004
Top Page Image Contents