APC NBRK0200 configurationmanual How to Install the Temperature/Humidity Sensor

Page 13

How to Install the Temperature/Humidity Sensor

1.Choose a location and install the temperature/humidity sensor. Avoid locations in direct sunlight or other locations that may affect the sensor reading, such as near windows, room entrances, air ducts, or other heat sources.

Note: When securing the sensor, tighten the tie wrap over the recessed channel of the sensor casing.

Vertical rail installation. Firmly install the sensor mount (25 x 25-mm [1 x 1-in] cable tie mount) at the location you selected. Then secure the sensor with a tie wrap.

Door-mount installation. For racks with a perforated door, use a tie wrap to secure the sensor.

Wall-mount installation. For a rough wall or porous surface, install the wall anchor at the location you selected.

Then, secure the sensor mount to the wall anchor using the screw provided. For a smooth wall or other smooth surface, firmly install the sensor mount (25 x 25-mm [1 x 1-in] cable tie mount). Secure the sensor to the sensor mount using a tie wrap.

2.Route the sensor cord to the Rack Monitor 200.

If you mounted the sensor on the door, be sure the door is fully open when you route the sensor cord.

The 4-m (13-ft) sensor cord can be extended to a maximum of 15 m (50 ft), using RJ-45 female-to-female couplings and standard CAT-5 cables.

3.Connect the sensor to the Rack Monitor 200 (see “How to Connect Sensors to Universal Sensor Ports” on page 10).

NetBotz Rack Monitor 200 Installation and Quick Configuration Manual

9

Image 13
Contents Installation Quick Configuration Manual Manual em Português está disponível no CD-ROM em anexo Contents Access the Rack Monitor Product Description IntroductionDocument Overview Additional DocumentationInventory Receiving InspectionInfraStruXure-certified Additional OptionsPhysical Description InstallationRear FrontDescription Toolless peg-mount installation How to Install the Rack MonitorRack-mount installation Power cord and network cable connections How to Install the Temperature/Humidity Sensor How to Connect Sensors to Universal Sensor Ports How to Connect an Alarm Beacon and Other Optional Devices How to Cascade Devices to A-Link Ports How to Wire to the Modbus Interface Server type Procedure Quick ConfigurationHow to disable the cookie requirement How to set up optionDhcp Server How to Update the Bootptab File Important Information about the Default GatewayHow to Use the APC Device IP Configuration Wizard Use apc for both User Name and Password How to Use ARP, Ping, and TelnetControl Console How to access the control consoleWeb Interface Access the Rack MonitorTelnet and SSH Simple Network Management Protocol Snmp Modbus How to Recover from a Lost PasswordNetBotz Rack Monitor 200 NBRK0200 SpecificationsSystem Specifications Temperature/Humidity Sensor AP9335THTwo-Year Factory Warranty Warranty and Life SupportTerms of warranty Non-transferable warranty ExclusionsWarranty claims Obtaining service General policy Life Support PolicyExamples of life-support devices Page Page Page Canada-ICES Radio Frequency InterferenceJapan-VCCI Taiwan-BSMI2008 990-3283-001