GBC 640T operation manual Feature guide, Film Shafts

Page 13

640t – Installation and Operating Instructions

5.Feature guide

This chapter helps you identify the main components of the laminator.

	Release liner take-up	Top film supply shaft
Pressure roller		Top film supply shaft
Pressure roller
Safety sensor
Feed table		Control panel
Feed table
Feed table
interlock latch
(under table)
		Roller pressure
Bottom supply shaft		handle
Bottom supply shaft

Foot switch

	Fig. 5-1. Laminator Identification.
Film Shafts	A. Release Liner Take-up
	Rewinds the release liner of pressure sensitive films.
	It consists of a shaft, core adapters, and cardboard
	core.
	B. Upper Unwind/Supply Shaft
	Holds the upper medium supply on the laminator.
	C. Lower Unwind/Supply Shaft
	Holds the lower medium supply on the laminator.

Fig. 5-2 Take-up and Supply Shafts.

Page 5-1

Image 13

Contents 640t Laminator 640t Installation and Operating Instructions Table of Contents 640t Installation and Operating Instructions General SafetyElectrical Limited 90-Day Warranty Warranty640t Installation and Operating Instructions 640t SpecificationsModifications Canada Class a Notice Avis Canada, Classe aPrior to Installation InstallationInstallation To set up the laminator for the first time640t Installation and Operating Instructions Film Shafts Feature guideIdler Bars, Unwind Shafts, Rewind Shafts Rollers and Safety SensorControl Panel and Print Clamp Emergency Stop and TableTension Controls Roller Pressure Handle Media Core Adapter Rewinder Power Power Cord and Foot Switch Temp Section Control PanelSpeed Section 640t Installation and Operating Instructions Operation Press RUN or the foot switchGeneral Operation To run the laminatorPoly-in and Poly-out Films Loading FilmRemoving and Installing the Feed Table Removing and Installing Print ClampTo remove existing films Loading Film Onto the Supply ShaftsTo load films onto the supply shafts Threading Film with a Threading CardTo web load films the machine 10. Bottom Film or Kraft Paper Stuck to Top Film 12. New Films Tacked to Old Films Loading Film by Tacking New Film to Existing FilmTo run the second pass Decaling in Two PassesTo run the first pass Tips For Threading Pressure Sensitive Adhesive PSA Film MountingPre-Coating Boards Mounting OnlyFilm Alignment Film Alignment and TensionFilm Tension To align the supply rollsTo test the web Clearing a Film Jam Wrap-upTo clear a jam Lamination Guide Cleaning The Rollers Operator MaintenanceTo clean the rollers and idler bar Caring for the 640t LaminatorSymptom Possible Cause Corrective Action Troubleshooting640t Installation and Operating Instructions Acco Brands Acco Canada Brampton