GBC 640T operation manual Power Power Cord and Foot Switch

Page 18

640t – Installation and Operating Instructions

Power

Power Cord and Foot Switch

Fig. 5-11. Power Panel.

A.On/Off Power Switch

The On/Off Power Switch is located at the back of the machine. Press the “I” on the switch to turn it on. The LCD will illuminate. The off position, marked “0”, turns the machine off.

B.Circuit Breaker

The Circuit Breaker will trip if there is too much load. Wait for 1 minute after the Circuit Breaker trips and press the switch to reset. If the machine fails to reset, see “Troubleshooting” on page 7-2.

C.Nomenclature Plate

Technical information is provided on the

Nomenclature Plate:

Serial Number

Voltage

Amps

Watts

Hertz

Fig. 5-12. Power Cord and Foot Switch.

A.Power Cord

The Power cord is a 220 VAC, NEMA 6-15P and fits a NEMA 6-15R.

B.Foot Switch

The Foot Switch allows the operator to start and stop the laminator while handling the item to be laminated.

Press the Foot Switch to run the laminator. Release it to stop the laminator.

When the Foot Switch is used and the Safety Sensor is blocked, the speed of the laminator drops to 3 fpm (0.9 mpm).

When the Feed Table is removed, the rollers will rotate if the Foot Switch is pressed. The machine will run at 3 fpm (0.9 mpm)

Page 5-6

Image 18
Contents 640t Laminator 640t Installation and Operating Instructions Table of Contents 640t Installation and Operating Instructions Safety GeneralElectrical Warranty Limited 90-Day Warranty640t Installation and Operating Instructions Specifications 640tCanada Class a Notice Avis Canada, Classe a ModificationsInstallation InstallationPrior to Installation To set up the laminator for the first time640t Installation and Operating Instructions Feature guide Film ShaftsRollers and Safety Sensor Idler Bars, Unwind Shafts, Rewind ShaftsEmergency Stop and Table Control Panel and Print ClampTension Controls Roller Pressure Handle Media Core Adapter Rewinder Power Power Cord and Foot Switch Control Panel Temp SectionSpeed Section 640t Installation and Operating Instructions General Operation Press RUN or the foot switchOperation To run the laminatorLoading Film Poly-in and Poly-out FilmsRemoving and Installing Print Clamp Removing and Installing the Feed TableLoading Film Onto the Supply Shafts To remove existing filmsThreading Film with a Threading Card To load films onto the supply shaftsTo web load films the machine 10. Bottom Film or Kraft Paper Stuck to Top Film Loading Film by Tacking New Film to Existing Film 12. New Films Tacked to Old FilmsDecaling in Two Passes To run the second passTo run the first pass Pre-Coating Boards MountingTips For Threading Pressure Sensitive Adhesive PSA Film Mounting OnlyFilm Tension Film Alignment and TensionFilm Alignment To align the supply rollsClearing a Film Jam Wrap-up To test the webTo clear a jam Lamination Guide To clean the rollers and idler bar Operator MaintenanceCleaning The Rollers Caring for the 640t LaminatorTroubleshooting Symptom Possible Cause Corrective Action640t Installation and Operating Instructions Acco Brands Acco Canada Brampton