GBC 640T operation manual Canada Class a Notice Avis Canada, Classe a, Modifications

Page 10

640t – Installation and Operating Instructions

FCC Note

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiated radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Canada Class A Notice - Avis Canada, Classe A

This Class A digital apparatus complies with Canadian ICES-003.

(Cet appareil numérique de las Classe A est conforme a la norme NMB-003 du Canada.

Modifications

Any modifications made to this device that are not approved by General Binding Corporation, an ACCO Brands Corporation, may void the authority granted to the user by the FCC and/or by Industry Canada to operate this equipment.

Toutes modifications apportées à ce dispositif et non approuvées par General Binding Corporation, an ACCO Brands Corporation annuleront le droit accordé à l’utilisateur par le FCC et/ou par Industrie Canada de faire fonctionner cet équipement

Page 3-2

Image 10
Contents 640t Laminator 640t Installation and Operating Instructions Table of Contents 640t Installation and Operating Instructions Safety GeneralElectrical Warranty Limited 90-Day Warranty640t Installation and Operating Instructions Specifications 640tCanada Class a Notice Avis Canada, Classe a ModificationsInstallation InstallationPrior to Installation To set up the laminator for the first time640t Installation and Operating Instructions Feature guide Film ShaftsRollers and Safety Sensor Idler Bars, Unwind Shafts, Rewind ShaftsEmergency Stop and Table Control Panel and Print ClampTension Controls Roller Pressure Handle Media Core Adapter Rewinder Power Power Cord and Foot Switch Temp Section Control PanelSpeed Section 640t Installation and Operating Instructions General Operation Press RUN or the foot switchOperation To run the laminatorLoading Film Poly-in and Poly-out FilmsRemoving and Installing Print Clamp Removing and Installing the Feed TableLoading Film Onto the Supply Shafts To remove existing filmsTo load films onto the supply shafts Threading Film with a Threading CardTo web load films the machine 10. Bottom Film or Kraft Paper Stuck to Top Film Loading Film by Tacking New Film to Existing Film 12. New Films Tacked to Old FilmsTo run the second pass Decaling in Two PassesTo run the first pass Pre-Coating Boards MountingTips For Threading Pressure Sensitive Adhesive PSA Film Mounting OnlyFilm Tension Film Alignment and TensionFilm Alignment To align the supply rollsTo test the web Clearing a Film Jam Wrap-upTo clear a jam Lamination Guide To clean the rollers and idler bar Operator MaintenanceCleaning The Rollers Caring for the 640t LaminatorTroubleshooting Symptom Possible Cause Corrective Action640t Installation and Operating Instructions Acco Brands Acco Canada Brampton