GBC 640T operation manual Media Core Adapter Rewinder

Page 17

640t – Installation and Operating Instructions

Media Core Adapter

Rewinder

Fig. 5-9. Media Core Adapter.

The Media Core Adapters hold and lock the rolls of film and release liner on the shafts to prevent side to side shifting. Grippers on the Core Adapters ensure proper tension on the film. The Supply Shaft Core Adaptors lock in place with a set screw. The release liner take-up Core Adaptors are held in place by friction.

Fig. 5-10. Rewinder Components.

A.Rewinder Core Adapters

The Rewinder Core Adapters are held in place using friction. They adapt to the provided 2-1/4 inch cardboard tube and most media tubes.

B.Rewinder Shaft

The Rewinder Shaft supports the Rewinder Core Chucks and tube.

C.Rewinder Cardboard Tube

The Rewinder Cardboard tube carries the release liner and media.

D.Core Adaptors

The Core Adaptors hold film and media.

E.Unwind/Supply Shaft

The Unwind/Supply Shaft holds film and media.

Page 5-5

Image 17
Contents 640t Laminator 640t Installation and Operating Instructions Table of Contents 640t Installation and Operating Instructions General SafetyElectrical Limited 90-Day Warranty Warranty640t Installation and Operating Instructions 640t SpecificationsModifications Canada Class a Notice Avis Canada, Classe aPrior to Installation InstallationInstallation To set up the laminator for the first time640t Installation and Operating Instructions Film Shafts Feature guideIdler Bars, Unwind Shafts, Rewind Shafts Rollers and Safety SensorControl Panel and Print Clamp Emergency Stop and TableTension Controls Roller Pressure Handle Media Core Adapter Rewinder Power Power Cord and Foot Switch Speed Section Control PanelTemp Section 640t Installation and Operating Instructions Operation Press RUN or the foot switchGeneral Operation To run the laminatorPoly-in and Poly-out Films Loading FilmRemoving and Installing the Feed Table Removing and Installing Print ClampTo remove existing films Loading Film Onto the Supply ShaftsTo web load films the machine Threading Film with a Threading CardTo load films onto the supply shafts 10. Bottom Film or Kraft Paper Stuck to Top Film 12. New Films Tacked to Old Films Loading Film by Tacking New Film to Existing FilmTo run the first pass Decaling in Two PassesTo run the second pass Tips For Threading Pressure Sensitive Adhesive PSA Film MountingPre-Coating Boards Mounting OnlyFilm Alignment Film Alignment and TensionFilm Tension To align the supply rollsTo clear a jam Clearing a Film Jam Wrap-upTo test the web Lamination Guide Cleaning The Rollers Operator MaintenanceTo clean the rollers and idler bar Caring for the 640t LaminatorSymptom Possible Cause Corrective Action Troubleshooting640t Installation and Operating Instructions Acco Brands Acco Canada Brampton