GBC 640T operation manual Electrical

Page 6

640t – Installation and Operating Instructions

Electrical

The laminator should be connected only to a source of power as indicated in these instructions and on the serial plate located on the rear of the laminator. Contact an electrician should the attachment plug provided with the laminator not match the receptacles at your location.

WARNING: Do not attempt to service or repair the laminator. Failure to observe this warning could result in severe personal injury or death.

Disconnect the plug from the receptacle and contact your dealer or distributor when one or more of the following has occurred.

The power supply cord or attachment plug is damaged.

Liquid has been spilled into the laminator.

The laminator is malfunctioning after being mishandled.

The laminator does not operate as described in these instructions.

CAUTION: The receptacle must be located near the equipment and easily accessible.

Disconnect the attachment plug from the receptacle to which it is connected and keep the power supply cord in your possession while moving the laminator.

Page 1-2

Image 6
Contents 640t Laminator 640t Installation and Operating Instructions Table of Contents 640t Installation and Operating Instructions Safety GeneralElectrical Warranty Limited 90-Day Warranty640t Installation and Operating Instructions Specifications 640tCanada Class a Notice Avis Canada, Classe a ModificationsInstallation InstallationPrior to Installation To set up the laminator for the first time640t Installation and Operating Instructions Feature guide Film ShaftsRollers and Safety Sensor Idler Bars, Unwind Shafts, Rewind ShaftsEmergency Stop and Table Control Panel and Print ClampTension Controls Roller Pressure Handle Media Core Adapter Rewinder Power Power Cord and Foot Switch Control Panel Temp SectionSpeed Section 640t Installation and Operating Instructions General Operation Press RUN or the foot switchOperation To run the laminatorLoading Film Poly-in and Poly-out FilmsRemoving and Installing Print Clamp Removing and Installing the Feed TableLoading Film Onto the Supply Shafts To remove existing filmsThreading Film with a Threading Card To load films onto the supply shaftsTo web load films the machine 10. Bottom Film or Kraft Paper Stuck to Top Film Loading Film by Tacking New Film to Existing Film 12. New Films Tacked to Old FilmsDecaling in Two Passes To run the second passTo run the first pass Pre-Coating Boards MountingTips For Threading Pressure Sensitive Adhesive PSA Film Mounting OnlyFilm Tension Film Alignment and TensionFilm Alignment To align the supply rollsClearing a Film Jam Wrap-up To test the webTo clear a jam Lamination Guide To clean the rollers and idler bar Operator MaintenanceCleaning The Rollers Caring for the 640t LaminatorTroubleshooting Symptom Possible Cause Corrective Action640t Installation and Operating Instructions Acco Brands Acco Canada Brampton