GBC 3064WF operation manual Sequence of Operations, Speed of 3f/m

GBC 3064WF Operation Manual

SEQUENCE OF OPERATIONS

GBC U.S &CE 3064WF

Effect of Fiber Optics on sequence of operation

Modes	Situation 1	Situation 2	Situation 3
Machine Run Mode	Normal operation	Interrupted fiber optic	Fiber optic beam cleared + all safety
	(No Interruption to any	beam or opened any	circuitries are closed
	safety circuitry & Fiber	safety circuitry.
	optic beam)High speed.
	Control panel:	Machine stops Instantly.	Machine will remain stationary until
	Forward Speed: Zero to	Use foot pedal to override	run switch is pressed.
	Max.	@ 3f/m.	Push RUN button switch to run
	Press “RUN” push		machine again (Normal operation)
	button to switch over		mode.
	from foot switch to the
	control panel.
	Foot switch:	Machine Runs @	Machine still remains at low voltage
	Forward Speed: Zero to	3f/m.	speed of 3f/m.
Forward Mode	Max.	(Automatic override from	Steps required to run at (various
	Note: Press variable	high to low voltage)	speed): The operator will have two
Press push button
	foot pedal to change		choices,
forward switch
	mode and take over
			Choice A:
	from control panel at
	preset speed.		1. Release foot pedal to stop machine.
			2. Press foot pedal again to start
			machine at original preset control
			panel knob speed (pot).
			Choice B:
			1. Press and hold “RUN” push button
			switch on the control panel while foot
			is still on pedal.
			2. Release foot pedal.
			3. Adjust speed using “speed knob”
	Reverse speed: Zero to	Machine stops Instantly.	Machine must not run. It will remain
	Max.	Use Foot pedal to	stationary.
	Press “Run” push	override @ 3f/m.	Push RUN button switch to run
	button to switch over		machine again at Normal operation
	from Foot switch to the		mode.
	Control panel.
Reverse Mode	Reverse speed: Zero to	Machine Runs @ 3f/m.	Machine still remains at low voltage
	Max.	(Automatic override from	speed of 3f/m.
Press Reverse	Note: Press foot pedal	high to low voltage)	Steps required to run at (various
Push button switch.	to change mode and		speed): The operator will have two
	take over from control		choices,
	panel.		Choice A:
			1. Release foot pedal to stop machine.
			2. Press foot pedal again to start
			machine at original preset control
			panel knob speed (pot).
			Choice B:
			1. Press and hold “RUN” push button
			switch on the control panel while foot
			is still on pedal.
			2. Release foot pedal.
			3. Adjust speed using “speed knob”

© 2005 General Binding Corporation Page 14