To unweb the laminator, Clearing a Film Jam Wrap-up

GBC 3064WF

To unweb the laminator

Unweb the laminator if you are changing film widths, cleaning the rollers or have finished using the machine for the day.

CAUTION: Do not cut yourself

1.Using the rear slitter, cut (1) the output from the web (Fig. 28).

2.Cut (2) remaining top film web between the idler bar and heat roller. PSA film cut the release liner too.

3.Cut (3) the film web between the lower film supply and the idler bar (Fig. 28).

CAUTION: Be careful not to cut any of the rollers!

4.Tilt the feed table.

5.Gap the main rollers and pull rollers.

6.Carefully grab hold of the web (top and bottom film), from the back operating position and pull towards you (Fig. 29).

7.Do not allow the adhesive side of the film to contact the heat or pull rollers.

Clearing a Film Jam (Wrap-up)

Film jams (wrap-ups) may occur if the film is loaded backwards or if the area at which film exits the equipment is blocked. The film, when jammed, wraps around the heat rollers or pulls rollers during webbing if webbing, if a Threading Card is not used.

To clear a jam:

1.Immediately stop the laminator by pressing “STOP” ( ).

2. Set motor direction to “REAR” ( ).

3.Use the footswitch to reverse the web until the wrap up is clear.

4.Raise the main roller and pull rollers.

5.Manually guide the web from the main rollers and pull rollers.

6.Once the film jam has been cleared, lower the main roller and pull rollers.

7.Refer to the section titled “START LAMINATING”.

Operation Manual

(2)

(1)

(3)

(2)

.......a PSA film or mount adhesive

Figure 28

PULL WEB

Figure 29

Page 20