GBC 3064WF operation manual Start Laminating

Page 18

GBC 3064WF

Start Laminating

1.At this point you should have your laminator Webbed with the appropriate material for your application.

2.The feed table should be in the normal operating position.

3.Close the main and Pull roll nips. Rollers should be closed.

4.Speed is set to 3 or less and “FRONT” ( ) motor direction is selected.

5.Press the “START” () button.

6.Set main roller pressure between 40% – 60% for laminating by turning the main roll lift handle.

CAUTION: If using PSA film, an air pocket may result between the main rollers and pull rollers. Raise the pull rollers to allow the air Pocket to pass.

7.Make any necessary film brake tension adjustments, pull/main roller pressure, and clutch and/ or rewind brake tension adjustments.

8.Position the item to be laminated on the feed table.

9.Align the leading edge of the item parallel to the heat roller nip (Fig. 25).

10.With both hands and an outward force push the image slower than the speed of the rollers into the nip of the heat rollers (Fig. 26).

CAUTION: Avoid forcing the image into the main roller nip as this action will cause the corners of the leading edge to buckle and create a wave.

Operation Manual

Figure 25

Figure 26

© 2005 General Binding Corporation

Page 18

Image 18
Contents ENG GBC 3064WF ENGTable of Contents Service Important Safety InstructionsImportant Safeguards GeneralWarranty SpecificationsPRE-INSTALLATION InstallationGBC 3064 WF Requires Power ON/OFF I/O Control GuideFeatures Guide Media Tables C & 3C Unwind / Rewind ComboRemovable Chill Idler Item a Upper Tension Idler Item a Lower Tension Idler Item BHeated Main Rollers Item a Main On Off I/O SwitchElectronic Safety Beam Item a Swing around control panel arm Item aPull Roll Lift handle Nip Pressure AdjustmentPull Roll Clutch Adjustment Knob Heated Main roll Lift handleSequence of Operations Speed of 3f/mOperating Instructions Film Loading & ThreadingTo load a roll of film Fig Webbing Thermal Film Using Threading Card Webbing PSA Film/Mount Adhesive Using Threading Card Start Laminating Method for Tacking New Film to Existing Film RollersTo unweb the laminator Clearing a Film Jam Wrap-upTo clear a jam Tips for Mounting Pre Coated Boards ApplicationsTips for Pre Coating Boards Tips for Single Sided laminationTips for Creating a Decal Tips for mounting a DecalTips For Thermal Encapsulation Tips for Accushield Speed / Temperature Control ART of LaminationHeat OutputMaintenance Caring For The GBC 3064WF LaminatorService Agreement Tension