GBC 3064WF operation manual Heat, Output

Page 25

GBC 3064WF

- A -

- B -

Figure 39

- A -

- B -

Figure 40

- A -

- B -

Figure 41

Operation Manual

Heat

The “READY” indicator may extinguish if the speed is set too fast for the material being laminated. Either lower the speed setting or press “STOP” ( ) and wait until the “READY” indicator illuminates. Operation of the laminator for more than thirty minutes at a time may necessitate a lower speed setting. It is recommended that, during periods of long runs, the items being laminated are alternated between thick and thin. Do not combine thick and thin items at the same time, as this will result in a poor edge seal around the thinner material. If you are unsure that the laminator is set at the proper speed for the item to be laminated, run a test piece (scrap) of the same or similar material through the Laminator. This procedure is recommended because rotating the heat roller prior to lamination will more evenly distribute the heat.

Make speed adjustments if necessary.

Output

1.“D” waves in the image (Fig. 39 A).

Check paper tension.

Paper may be damp or not dry.

2.“D” waves in the laminate (Fig. 39 B).

Check main roller pressure.

Check pull roller pressure.

3.Straight waves in output (Fig. 40 A).

Check operational settings for materials being used.

Check clutch tension.

4.Indent waves in output after pull rollers

Insufficient cooling time.

Output was handled prior to cooling.

Use cooling feature if not on.

Machine was stopped on print.

5.Angled waves in the output

Main air Supply setting

Check main Roller Pressure.

Check main roller pressure.

Check pull roller pressure.

Check for Paper Tension.

© 2005 General Binding Corporation

Page 25

Image 25
Contents ENG ENG GBC 3064WFTable of Contents Important Safeguards Important Safety InstructionsService GeneralSpecifications WarrantyInstallation PRE-INSTALLATIONGBC 3064 WF Requires Control Guide Power ON/OFF I/OFeatures Guide Unwind / Rewind Combo Media Tables C & 3CRemovable Chill Idler Item a Lower Tension Idler Item B Upper Tension Idler Item aElectronic Safety Beam Item a Main On Off I/O SwitchHeated Main Rollers Item a Swing around control panel arm Item aPull Roll Clutch Adjustment Knob Nip Pressure AdjustmentPull Roll Lift handle Heated Main roll Lift handleSpeed of 3f/m Sequence of OperationsFilm Loading & Threading Operating InstructionsTo load a roll of film Fig Webbing Thermal Film Using Threading Card Webbing PSA Film/Mount Adhesive Using Threading Card Start Laminating Rollers Method for Tacking New Film to Existing FilmClearing a Film Jam Wrap-up To unweb the laminatorTo clear a jam Tips for Pre Coating Boards ApplicationsTips for Mounting Pre Coated Boards Tips for Single Sided laminationTips for mounting a Decal Tips for Creating a DecalTips For Thermal Encapsulation Tips for Accushield ART of Lamination Speed / Temperature ControlOutput HeatCaring For The GBC 3064WF Laminator MaintenanceTension Service Agreement