Stylus Photo R300/R310 | Revision A |
Reinstalling "Clutch"
Make sure that the dowel of "Shaft, LD Roller" is fitted in the installing hole of "Clutch".
Make sure that "Extension Spring, 0.143" is securely set on the hooks of "Clutch" and "Shaft, LD Roller".
Do not set "Extension Spring, 0.143" in twisted form.
Make sure that "Clutch" rotates correctly.
Reinstalling "Shaft, LD Roller"
Do not touch "LD Roller".
Check if the straight part of "Torsion Spring, 137.7" is set between the 2 cams of "Shaft, LD Roller".
Torsion Spring, 137.7
Make sure that the straight part of "Torsion |
|
|
| LD Roller | |
Spring, 137.7" is set between the two cams. |
|
|
|
|
|
Figure 2-23. Position of "Torsion Spring, 137.7"
Reinstalling "Holder, Shaft Assy."
Check if the hooks (x2), the dowel and the ribs (x5) of "Holder, Shaft Assy." are correctly secured.
Check if the connector cable of "PE Sensor" and "Cable, Head" are installed at the correct position of "Holder, Shaft Assy.".
Do not touch "LD Roller".
Do not damage the teeth of "Spur Gear, 36.8" and "Combination Gear, 27.2, 19.2".
Combination Gear, 27.2, 19.2
Spur Gear, 36.8
Figure 2-24. "Spur Gear, 36.8" and "Combination Gear, 27.2, 19.2"
ADJUSTMENT When having replaced "Shaft, LD Roller", apply G-46 grease to
REQUIRED the specified points in adequate dose. (Refer to Chapter 4 "MAINTENANCE")
When having replaced or removed "Holder, Shaft Assy.", implement the following adjustment. (Refer to Chapter 3 "ADJUSTMENT")
First Dot Adjustment
DISASSEMBLY AND ASSEMBLY | Disassembly | 53 |