Epson R310 service manual Removing Print Head, PG Adjustment

Stylus Photo R300/R310 Revision A

2.3.12 Removing Print Head

†External View

6.Remove the screws (x2) which secure "Print Head" with Phillips screwdriver (No.1).

7.Disconnect "Cable, Head" from the connector of "Print Head" while slightly lifting "Print Head". Then, remove "Print Head".

Carriage Unit

Carriage Lock

Hooks

Holder, IC

Hooks

Holder, FFC

C.B.P 2.5x6 (3-5kgf•cm)

Cable, Head

Print Head

CAUTION Do not touch and/or damage the nozzle surface of "Print Head" when handling it.

† Check if "Head FFC" is correctly connected to the connector of "Print Head".

†Check if "Print Head" is correctly set to "Carriage Unit".

C.B.B (P2) 2.5x8 (3-5kgf•cm)

ADJUSTMENT †

REQUIRED

When having removed or replaced "Print Head", implement the adjustment in the following order.

(Refer to Chapter 3 "ADJUSTMENT")

1.	Ink Charge (When Replaced)
2.	Head ID Input (When Replaced)

Figure 2-28. Removing "Print Head"

†Parts/Units which should be removed before removing "Print Head". Paper Support Assy./Housing, Upper/Housing, Middle

†Procedure for Removing

1.Remove all the ink cartridges from "Carriage Unit".

2.Release "Carriage Lock" with the tweezers or alike, then move "Carriage Unit" to the centre of the printer.

3.Remove the screw (x1) which secures "Holder, FFC" with the No. 1 driver.

4.Slightly inflect the lower part of "Holder, FFC", release the hooks (x3) by sliding it downward. Then, remove "Holder, FFC".

5.Release the hooks (x2) which secure "Holder, IC", and remove "Holder, IC" upward.

3.	PG Adjustment
4.	First Dot Adjustment
5.	PW Sensor Adjustment
6.	Head Angular Adjustment
7.	Bi-D Adjustment

DISASSEMBLY AND ASSEMBLY Disassembly 56