Stylus Photo R300/R310 | Revision A |
Reinstalling "CSIC Board"
Check if "CSIC Board" is secured correctly.
Reinstalling "PW Sensor Board"
Check if "PW Sensor FFC" is correctly connected.
Check if "PW Sensor Board" is correctly secured with "Cap, PW Sensor".
Reinstalling "CR Encoder Sensor Board"
Check if "CR Encoder Sensor Board" is correctly secured.
Check if "CR Encoder Sensor Board" is correctly connected.
Reinstalling "Holder, Scale, Right (Left)"
Check if "Slider, Holder, Scale" is set.
Slider, Holder, Scale
Figure 2-33. Reinstalling "Slider, Holder, Scale"
Reinstalling "Carriage Unit"
Check if "Timing Belt" is correctly set to the installing groove of "Carriage Unit".
Check if "Grounding Plate, Head" is installed to the proper position of "Carriage Unit".
Grounding Plate, Head
Figure 2-34. Installing Position of "Grounding Plate, Head"
Reinstalling "CR Scale"
Make sure that "Extension Spring, 3.289" is not twisted.
Make sure to pass "CR Scale" through the slit of "CR Encoder Sensor".
Make sure to install "CR Scale" the cut-part on the left edge up.
Figure 2-35. Reinstalling "CR Scale"
Reinstalling "Guide, CR"
Screw in the order as shown in the figure.
CAUTION Do not adhere the grease at the contact point of ’Carriage’ and "CR Lock Lever". Otherwise, fatal error may possible occur because ’CR Lock Lever’ is not moved.
DISASSEMBLY AND ASSEMBLY | Disassembly | 61 |