Epson T88II manual

Page 21

WARNING:

Make sure that you use the EPSON PS-170 power supply or equivalent. Using an incorrect power supply may cause fire or electrical shock.

CAUTIONS:

When connecting or disconnecting the power supply from the printer, make sure that the power supply is not plugged into an electrical outlet. Otherwise you may damage the power supply or the printer.

If the power supply’s rated voltage and your outlet’s voltage do not match, contact your dealer for assistance. Do not plug in the power cord. Otherwise, you may damage the power supply or the printer.

1.Make sure that the printer’s power switch is turned off, and the power supply’s power cord is unplugged from the electrical outlet.

2.Check the label on the power supply to make sure that the voltage required by the power supply matches that of your electrical outlet.

3.Plug in the power supply’s cable as shown below. Notice that the flat side of the plug faces down.

Note:

To remove the DC cable connector, make sure that the power supply’s power cord is unplugged; then grasp the connector at the arrow and pull it straight out.

1-6Setting Up the Printer

Image 21

Contents TM-T88II Series Printer Parts and Labels VorsichtLabels Installing and Replacing Paper Setting Up the PrinterSolving Problems Quick ReferencePage FCC Compliance Statement For American UsersIii Declaration of Conformity EMI and Safety Standards Applied Setting Up and Using About This ManualReference Introduction FeaturesPrinting Application SoftwareOptions and Accessories Specified Thermal Roll Paper NTP080-80 Ordering Paper and SuppliesOther Qualified Suppliers for Thermal Paper Jujo Thermal Oy FinlandKanzaki Specialty Papers, Inc Using the Printer Xii Setting Up the Printer Setting Up the PrinterUnpacking Connecting the Cables and Grounding the Printer Connecting the computer2Setting Up the Printer Connecting the Drawer Anschließen der Lade 4Setting Up the PrinterGrounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown 10Setting Up the Printer Using the Power Switch CoverSelf Test Running the self testSelf test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and SettingsUsing the Printer Using the PrinterOperating the Control Panels Control PanelPanel lights 2Using the PrinterTroubleshooting TroubleshootingGeneral problems Printing problemsError light is off, but nothing is printed 2TroubleshootingPrinting is poor Cleaning the print head Paper handling problemsPaper is jammed inside the printer 4Troubleshooting Auto cutter is jammed Auto cutter problems6Troubleshooting Hexadecimal Dump Printing Specifications Reference InformationReference Information 2Reference Information Line spacing default 4.23 mm 1/6Paper roll single-ply Size Paper SpecificationsElectrical Characteristics CurrentConsumption at Temperature Environmental ConditionsHumidity Setting the DIP Switches Dip Switch and Paper Near End SettingsDIP switch functions Serial interface specification2Dip Switch and Paper Near End Settings Print Density Selection Dip Switch and Paper Near End Settings A-34Dip Switch and Paper Near End Settings Parallel interface specificationDip Switch and Paper Near End Settings A-5 6Dip Switch and Paper Near End Settings Changing the DIP switch settingsDip Switch and Paper Near End Settings A-7 Adjusting the Paper Near End DetectorEpson Sales Subsidiaries B-1 Epson Sales Subsidiaries2EPSON Sales Subsidiaries