Epson T88II manual Dip Switch and Paper Near End Settings A-5

Page 46

Notes:

•Changes in DIP switch settings (excluding switch 2-8 interface reset signal) are recognized only when the printer power is turned on or when the printer is reset by using the interface. If the DIP switch setting is changed after the printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

•If you turn on DIP switch 2-8 while the printer is turned on, the printer may be reset, depending on the signal state. DIP switches should not be changed while the printer power is on.

•If the print density is set to level 3 or 4, the printing will be at the low speed.

•In a low power consumption, printing is fixed to 70mm/sec.

Dip Switch and Paper Near End Settings A-5

Image 46

Contents TM-T88II Series Vorsicht Printer Parts and LabelsLabels Solving Problems Setting Up the PrinterInstalling and Replacing Paper Quick ReferencePage For American Users FCC Compliance StatementIii Declaration of Conformity EMI and Safety Standards Applied About This Manual Setting Up and UsingReference Printing FeaturesIntroduction Application SoftwareOptions and Accessories Ordering Paper and Supplies Specified Thermal Roll Paper NTP080-80Jujo Thermal Oy Finland Other Qualified Suppliers for Thermal PaperKanzaki Specialty Papers, Inc Using the Printer Xii Setting Up the Printer Setting Up the PrinterUnpacking Connecting the computer Connecting the Cables and Grounding the Printer2Setting Up the Printer Connecting the Drawer 4Setting Up the Printer Anschließen der LadeConnecting the Power Supply Grounding the PrinterPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown Self Test Using the Power Switch Cover10Setting Up the Printer Running the self testSelf test printing Please press the Paper Feed button Adjustments and Settings 12Setting Up the PrinterOperating the Control Panels Using the PrinterUsing the Printer Control Panel2Using the Printer Panel lightsGeneral problems TroubleshootingTroubleshooting Printing problems2Troubleshooting Error light is off, but nothing is printedPrinting is poor Paper handling problems Cleaning the print headPaper is jammed inside the printer 4Troubleshooting Auto cutter problems Auto cutter is jammed6Troubleshooting Hexadecimal Dump Reference Information Printing SpecificationsReference Information Line spacing default 4.23 mm 1/6 2Reference InformationPaper Specifications Paper roll single-ply SizeCurrent Electrical CharacteristicsConsumption at Environmental Conditions TemperatureHumidity DIP switch functions Dip Switch and Paper Near End SettingsSetting the DIP Switches Serial interface specification2Dip Switch and Paper Near End Settings Dip Switch and Paper Near End Settings A-3 Print Density SelectionParallel interface specification 4Dip Switch and Paper Near End SettingsDip Switch and Paper Near End Settings A-5 Changing the DIP switch settings 6Dip Switch and Paper Near End SettingsAdjusting the Paper Near End Detector Dip Switch and Paper Near End Settings A-7Epson Sales Subsidiaries Epson Sales Subsidiaries B-12EPSON Sales Subsidiaries