Epson T88II manual Dip Switch and Paper Near End Settings A-3, Print Density Selection

Page 44

Print Density Selection

Print Density	SW 2-3	SW 2-4

1 Low power comsumption mode	ON	ON

2(Normal)	OFF	OFF

3	ON	OFF

4 (Dark)	OFF	ON

Notes:

•With the optional RS-485 interface, DIP switches 2-7 and 2-8 are disabled.

•Changes in DIP switch settings (excluding switches 2-7 and 2-8 interface reset signals) are recognized only when the printer power is turned on or when the printer is reset by using the interface. If the DIP switch setting is changed after the printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

•If you turn on DIP switch 2-7 or 2-8 while the printer is turned on, the printer may be reset, depending on the signal state. DIP switches should not be changed while the printer power is on.

•If the print density is set to level 3 or 4, the printing will be at the low speed.

•In a low power consuption, printing speed is fixed to 70 mm/sec.

Dip Switch and Paper Near End Settings A-3

Image 44

Contents TM-T88II Series Vorsicht Printer Parts and LabelsLabels Setting Up the Printer Installing and Replacing PaperSolving Problems Quick ReferencePage Iii FCC Compliance StatementFor American Users Declaration of Conformity EMI and Safety Standards Applied Reference Setting Up and UsingAbout This Manual Features IntroductionPrinting Application SoftwareOptions and Accessories Ordering Paper and Supplies Specified Thermal Roll Paper NTP080-80Kanzaki Specialty Papers, Inc Other Qualified Suppliers for Thermal PaperJujo Thermal Oy Finland Using the Printer Xii Unpacking Setting Up the PrinterSetting Up the Printer 2Setting Up the Printer Connecting the Cables and Grounding the PrinterConnecting the computer Connecting the Drawer 4Setting Up the Printer Anschließen der LadeConnecting the Power Supply Grounding the PrinterPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown Using the Power Switch Cover 10Setting Up the PrinterSelf Test Running the self testSelf test printing Please press the Paper Feed button Adjustments and Settings 12Setting Up the PrinterUsing the Printer Using the PrinterOperating the Control Panels Control Panel2Using the Printer Panel lightsTroubleshooting TroubleshootingGeneral problems Printing problemsPrinting is poor Error light is off, but nothing is printed2Troubleshooting Paper is jammed inside the printer Cleaning the print headPaper handling problems 4Troubleshooting Auto cutter problems Auto cutter is jammed6Troubleshooting Hexadecimal Dump Reference Information Printing SpecificationsReference Information Line spacing default 4.23 mm 1/6 2Reference InformationPaper Specifications Paper roll single-ply SizeConsumption at Electrical CharacteristicsCurrent Humidity TemperatureEnvironmental Conditions Dip Switch and Paper Near End Settings Setting the DIP SwitchesDIP switch functions Serial interface specification2Dip Switch and Paper Near End Settings Dip Switch and Paper Near End Settings A-3 Print Density SelectionParallel interface specification 4Dip Switch and Paper Near End SettingsDip Switch and Paper Near End Settings A-5 Changing the DIP switch settings 6Dip Switch and Paper Near End SettingsAdjusting the Paper Near End Detector Dip Switch and Paper Near End Settings A-7Epson Sales Subsidiaries Epson Sales Subsidiaries B-12EPSON Sales Subsidiaries