Epson T88II manual 2Dip Switch and Paper Near End Settings

Page 43

Transmission Speed

Transmission Speed (BPS)-bits per second	1-7	1-8

2400	ON	ON

4800	OFF	ON

9600	ON	OFF

19200	OFF	OFF

Set 2

	SW	Function	ON	OFF

	2-1	Handshaking (BUSY	Receive buffer full	Off line or
	2-1	condition)	Receive buffer full	receive buffer full

	2-2	Reserved: do not	Fixed to OFF
	2-2	change settings	Fixed to OFF

	2-3	Selects print density	Refer to table below

	2-4
	2-4

	2-5	Reserved: do not	Fixed to OFF
	2-5	change settings	Fixed to OFF

	2-6	Reserved: do not	Fixed to OFF
	2-6	change settings	Fixed to OFF

	2-7	I/F pin 6 reset signal	Enabled	Disabled

	2-8	I/F pin 25 reset signal	Enabled	Disabled

A-2Dip Switch and Paper Near End Settings

Image 43

Contents TM-T88II Series Printer Parts and Labels VorsichtLabels Quick Reference Setting Up the PrinterInstalling and Replacing Paper Solving ProblemsPage For American Users FCC Compliance StatementIii Declaration of Conformity EMI and Safety Standards Applied About This Manual Setting Up and UsingReference Application Software FeaturesIntroduction PrintingOptions and Accessories Specified Thermal Roll Paper NTP080-80 Ordering Paper and SuppliesJujo Thermal Oy Finland Other Qualified Suppliers for Thermal PaperKanzaki Specialty Papers, Inc Using the Printer Xii Setting Up the Printer Setting Up the PrinterUnpacking Connecting the computer Connecting the Cables and Grounding the Printer2Setting Up the Printer Connecting the Drawer Anschließen der Lade 4Setting Up the PrinterGrounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown Running the self test Using the Power Switch Cover10Setting Up the Printer Self TestSelf test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and SettingsControl Panel Using the PrinterUsing the Printer Operating the Control PanelsPanel lights 2Using the PrinterPrinting problems TroubleshootingTroubleshooting General problems2Troubleshooting Error light is off, but nothing is printedPrinting is poor Paper handling problems Cleaning the print headPaper is jammed inside the printer 4Troubleshooting Auto cutter is jammed Auto cutter problems6Troubleshooting Hexadecimal Dump Reference Information Printing SpecificationsReference Information 2Reference Information Line spacing default 4.23 mm 1/6Paper roll single-ply Size Paper SpecificationsCurrent Electrical CharacteristicsConsumption at Environmental Conditions TemperatureHumidity Serial interface specification Dip Switch and Paper Near End SettingsSetting the DIP Switches DIP switch functions2Dip Switch and Paper Near End Settings Print Density Selection Dip Switch and Paper Near End Settings A-34Dip Switch and Paper Near End Settings Parallel interface specificationDip Switch and Paper Near End Settings A-5 6Dip Switch and Paper Near End Settings Changing the DIP switch settingsDip Switch and Paper Near End Settings A-7 Adjusting the Paper Near End DetectorEpson Sales Subsidiaries B-1 Epson Sales Subsidiaries2EPSON Sales Subsidiaries