Boca Research FSP 44 Mini/Micro?, Print SPEED?, Diagnostic MODE?, Ticket TYPE?, Status ENABLED?

Page 17

MINI/MICRO?

Defines the type of printer.

MINI Is for a printer with a Cutter Assembly (factory default)

MICRO Is for a printer without a Cutter Assembly

PRINT SPEED?

Controls the speed the ticket travels at. Also effects the print quality.

The numbers range from 0 - FASTEST to 7 - SLOWEST. 3 is factory default.

DIAGNOSTIC MODE?

Please consult your Programming Guide

Your choices are YES or NO. NO is factory default.

TICKET TYPE?

Defines how the optos are configured on the paper guide assembly.

NORMAL Both optos are inline with each other (usually mounted on a black bracket) ATM Feed opto is mounted under the thermal head and cut opto is attached to the cutter assembly.

LABEL Same as ATM but the cut opto is a see through type.

SPECIAL TICKET This option is for a printer with a ticket load switch. (factory default)

STATUS ENABLED?

Sets status response protocols.

Here are the following choices:

NONE

Disables the XON/XOFF and status response protocols

SERIAL

Enables the XON/XOFF and status response protocol for the serial port (factory default)

PARALLEL

Enables bi-directional parallel statusresponses if printer is configured as bi-directional.

SER/PAR

Enablesb both bi-directional parallel and serial status responses

USB

Enables USB status responses

USB/SER

Enables USB and serial status responses

USB/PAR

Enables USB and bi-directional parallel

USB/SER/PAR

Enables USB, bi-directional parallel and serial status responses

TRANSPARENT MODE?

Please consult your Programming Guide

Your choices are YES (Enabled) or NO (Disabled). YES is factory default.

PAPER MODE?

Is generally used only for test purposes. It may also be used on roll stock with no black marks on the ticket.

Your choices are YES (Enabled) or NO (Disabled). NO is factory default.

HEAD DPI?

Defines thermal head dpi (dots per inch)

Your choices are 200 or 300. 300 is factory default.

11

Image 17
Contents FSP 42/44/46 Flight Strip Printer Boca SYSTEMS, INC Table of Contents Table of Figures and Appendices FCC Notice Warranty Information Introduction Boca Unpacking the PrinterControl Panel LCD Output Slot Hopper Mounting Holes Tour of Your PrinterCutter Assembly MAY Vary Page Configuration MAY Vary Loading Flight Strips InstallationThermal Menu Test Standard ConfigurationBaud RATE? Test Ticket TYPE?Print Head TYPE? Status ENABLED? Diagnostic MODE?MINI/MICRO? Print SPEED?Special HEAD? Default SettingPath TYPE? Buffer MODE?DEC CUT2 COUNT? INC CUT2 COUNT?Sided PRINTER? Park TICKET?Software BUSY? Flash ACK MODE?BI-DIRECTIONAL? Test TICKET?This Section has Been Removed Error No Description Control Panel IndicatorSerial Pinouts Interface PinoutsTypical RS232 Pin Connections Parallel PinoutsThermal Paper Theory & Specification Optical Device see figure Maintenance and AdjustmentsPaper Guide and Print Head Assembly Optical Device Ticket Load SwitchRubber Drive Roller Platen Thermal Print HeadPrint Head removal Logic Board Cutter AssemblyGeneral Cleaning Parts List Troubleshooting Guide Printer Skips Tickets While Printing No Print OUTPrinter Skips Tickets and Dies Ticket JAM Entering the Cutter Area