Boca Research FSP 42, FSP 46, FSP 44 technical manual Print Head removal

Page 28

Print Head release lever.

Adjustment set screws

Figure 9a - Print Head removal

Remove these two unmarked screws to replace print head.

Figure 9b - Print Head removal

		.

Figure 9c - Print Head removal		Figure 9d
	Clean this surface
	Clean this surface

Head is installed wrong. Should no be sitting on top of the cutter.

Figure 9e 24

Image 28

Contents FSP 42/44/46 Flight Strip Printer Boca SYSTEMS, INC Table of Contents Table of Figures and Appendices FCC Notice Warranty Information Introduction Unpacking the Printer BocaTour of Your Printer Control Panel LCD Output Slot Hopper Mounting HolesCutter Assembly MAY Vary Page Configuration MAY Vary Installation Loading Flight StripsThermal Standard Configuration Menu TestPrint Head TYPE? Test Ticket TYPE?Baud RATE? Diagnostic MODE? Status ENABLED?MINI/MICRO? Print SPEED?Default Setting Special HEAD?Path TYPE? Buffer MODE?INC CUT2 COUNT? DEC CUT2 COUNT?Sided PRINTER? Park TICKET?Flash ACK MODE? Software BUSY?BI-DIRECTIONAL? Test TICKET?This Section has Been Removed Control Panel Indicator Error No DescriptionInterface Pinouts Serial PinoutsTypical RS232 Pin Connections Parallel PinoutsThermal Paper Theory & Specification Paper Guide and Print Head Assembly Maintenance and AdjustmentsOptical Device see figure Ticket Load Switch Optical DeviceThermal Print Head Rubber Drive Roller PlatenPrint Head removal General Cleaning Cutter AssemblyLogic Board Parts List Troubleshooting Guide No Print OUT Printer Skips Tickets While PrintingPrinter Skips Tickets and Dies Ticket JAM Entering the Cutter Area