Boca Research FSP 44, FSP 46, FSP 42 technical manual FCC Notice

Page 5

FCC NOTICE

NOTE: The equipment has been tested and found to comply with the limits for a class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radi- ate radio frequency energy and , if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference, and

2.This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This unit was tested with shielded cables on the peripheral devices. Shielded cables must be used with the unit to insure compliance.

i

Image 5
Contents FSP 42/44/46 Flight Strip Printer Boca SYSTEMS, INC Table of Contents Table of Figures and Appendices FCC Notice Warranty Information Introduction Boca Unpacking the PrinterControl Panel LCD Output Slot Hopper Mounting Holes Tour of Your PrinterCutter Assembly MAY Vary Page Configuration MAY Vary Loading Flight Strips InstallationThermal Menu Test Standard ConfigurationBaud RATE? Test Ticket TYPE?Print Head TYPE? Status ENABLED? Diagnostic MODE?MINI/MICRO? Print SPEED?Special HEAD? Default SettingPath TYPE? Buffer MODE?DEC CUT2 COUNT? INC CUT2 COUNT?Sided PRINTER? Park TICKET?Software BUSY? Flash ACK MODE?BI-DIRECTIONAL? Test TICKET?This Section has Been Removed Error No Description Control Panel IndicatorSerial Pinouts Interface PinoutsTypical RS232 Pin Connections Parallel PinoutsThermal Paper Theory & Specification Optical Device see figure Maintenance and AdjustmentsPaper Guide and Print Head Assembly Optical Device Ticket Load SwitchRubber Drive Roller Platen Thermal Print HeadPrint Head removal Logic Board Cutter AssemblyGeneral Cleaning Parts List Troubleshooting Guide Printer Skips Tickets While Printing No Print OUTPrinter Skips Tickets and Dies Ticket JAM Entering the Cutter Area