SPECIAL HEAD?
Is used when a special paper path size is installed (2.125”, 2.5”, 2.7”...) Here are the following choices:
NO | NO special head (factory default) |
ON P1 | SINGLE PATH PRINTER ONLY. DUAL PATH PRINTER PATH #1 |
ON P2 | DUAL PATH PRINTER PATH #2 |
ON BOTH | DUAL PATH PRINTER BOTH PATHS |
REV ADJ2 P1 | DUAL & SINGLE PATH PRINTER WITH REV ADJ2 PATH ONLY |
REV ADJ2 P2 | DUAL PATH PRINTER WITH REV ADJ2 PATH ONLY |
REV ADJ BOTH | DUAL PATH PRINTER WITH REV ADJ2 PATH ONLY |
PATH TYPE?
Defines the number of paper paths used.
Here are the following choices:
PATH 1 | Locks a Dual path printer onto path#1 (all single path printers) (factory default) |
PATH 2 | Locks a Dual path printer onto path #2 |
DUAL | Is used for Dual path printer |
DUAL SUPPLY | Please consult your programming Guide (Dual Printer Supplement) |
VENTEK DUAL | Special settings only used by certain customers. |
BUFFER MODE?
Defines when the printer will go busy.
Here are the following choices:
SINGLE MODE 1 | Go busy after each print command inserted in buffer |
SINGLE MODE 2 | Go busy after receiving <p> command |
MULTIPLE MODE | Go busy when the input buffer is full (~4k) (factory default) |
CLEAR DOWNLOAD?
Clears those items downloaded by the operator (PCX or softfonts).
Your choices are YES or NO.
DEFAULT SETTING
Resets the printer back to the factory default setting.
Your choices are YES or NO.
INC CUT1 COUNT?
Enables the operator to move the cut or tear position to the left (towards the ticket entrance area). Cut counts are increments of .003” for 300dpi and .002” for 200dpi. The count value is changed by depressing CHOICES.
16 is factory default.
DEC CUT1 COUNT?
Enables the operator to move the cut or tear position to the right (towards the ticket exit area). Cut counts are decrements of .003” for 300dpi and .002” for 200dpi. The count value is changed by depressing CHOICES. 16 is factory default.
12