Airlink101 APSUSB2 manual Configuring Network Setting

Page 7

4. Configuring Network Setting

Before configuring the Print Server’s network setting, please take note of your computer’s TCP/IP setting.

Step 1 Click on Start, Run, and type command (for Windows 95/98/ME) or cmd (for Windows 2000/XP) and click OK.

Step 2 At the command prompt, type ipconfig and press Enter.

Step 3 Write down the information for the IP Address, Subnet Mask, and Default Gateway. You will need these information later.

Step 4 Run the PS Utility by going to Start, (All) Programs, PS Utility, PS Utility v2.00.

Step 5 Make sure the Print Server is listed under the Device Name and click on Change IP Address.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Port USB Print Server Model # APSUSB2 User’s Manual Table of Contents Introduction Package ContentsSystem Requirements Connecting the Print Server Hardware InstallationInstalling PS Utility Click Next Click Yes Click Finish Configuring Network Setting Click OK Verifying Network Connection Running PS Wizard Click Next Page Page Performing Operating System Print Test Click on Start, Settings, Printers and FaxesPage Using the PS-Utility Click on the Show Web Setup button in PS-Utility Using the Web Configuration UtilitySystem Status ManagementPrinter Status Server Device ConfigurationTCP/IP Protocol NetBEUI Protocol AppleTalk Print Test ToolsAbout ResetFactory Reset HelpPrinting in Mac OS Using RendezvousPage Page For Mac OS Setting AppleTalk/LPR PrintingPage Page To set up the Print Server for AppleTalk printing To print from Mac OS Client Workstations Page Network Data Transfer Rate 10/100 Mbps Product SpecificationsStandard Snmp Technical Support Appendix
Related manuals
Manual 14 pages 62.72 Kb
Top Page Image Contents