Airlink101 APSUSB2 manual Hardware Installation, Connecting the Print Server

Page 4

2 Hardware Installation

2.1 Connecting the Print Server

Warning: Only a USB printer may be connected to the USB port of the Print Server. Connecting any other USB device to the Print Server may damage the Print Server.

Note: Do not plug the power cord to the Print Server until you have reached Step 4 of this section.

Step 1Connect one end of the Ethernet cable to the RJ-45 port of the Print Server and attach the other end of the cable to a router.

Step 2 Make sure all the printers are powered OFF, then connect one end of the printer cable to the printer port of the Print Server and attach the other end of the cable to the printer port of the printer.

Step 3 Power ON the printer(s).

Step 4 Plug one end of the power cord into the Print Server and the other end into an electrical outlet.

3

Image 4

Contents Port USB Print Server Model # APSUSB2 User’s Manual Table of Contents Introduction Package ContentsSystem Requirements Hardware Installation Connecting the Print ServerInstalling PS Utility Click Next Click Yes Click Finish Configuring Network Setting Click OK Verifying Network Connection Running PS Wizard Click Next Page Page Click on Start, Settings, Printers and Faxes Performing Operating System Print TestPage Using the PS-Utility Using the Web Configuration Utility Click on the Show Web Setup button in PS-UtilitySystem Status ManagementPrinter Status Configuration Server DeviceTCP/IP Protocol NetBEUI Protocol AppleTalk Tools Print TestReset Factory ResetHelp AboutUsing Rendezvous Printing in Mac OSPage Page Setting AppleTalk/LPR Printing For Mac OSPage Page To set up the Print Server for AppleTalk printing To print from Mac OS Client Workstations Page Network Data Transfer Rate 10/100 Mbps Product SpecificationsStandard Snmp Appendix Technical Support

Related manuals

Manual 14 pages 62.72 Kb