Avery 676 user manual Lubrication Procedure, Composition Iglide Bearings

Page 45

Lubrication Procedure

General

The 676 series printers are factory equipped with either composition bearings not requiring lubrication, pre-lubricated bronze bearings, or pre-lubricated needle bearings. Periodic cleaning of the printer and removal of dust will greatly enhance the length of the time the printer will function.

Composition (Iglide) Bearings

1)If field replacement of an assembly fitted with a plastic bearing is performed, a single drop of spindle oil should be applied to assist in bearing break-in.

2)If, after long use, a plastic bearing starts to "squeak", disassemble the component containing the bearing and lightly abrade the shaft surface. Clean the bearing (dust or old oil) with alcohol, re-lubricate with 1 drop of light oil and reassemble.

No other printer lubrication should be required in normal use.

User Manual Model 676 LOKPRINT®

Maintenance • 39

Image 45

Contents Manual Edition August Model 676 LokprintThis page intentionally blank Contents Adjustments Scope Page Safety Issues / Warnings ScopeIntroduction Limited Warranty Warranty InformationService PartsPrinter Description Description / SpecificationsDescription / Specifications Printer Specification Personal Computer Specifications Location of Printer Customer ResponsibilityCustomer Responsibility Printer Unpacking / Installation AC Power LineUnpacking Avery Dennison 676LKP Tool KIT #371391 Inventory of ComponentsFuses must be between points a and B as shown not B and C Fuse ConfigurationInstalling the PC Interface Cable Installing the Power CordInstalling the PC Software TCB Dip Switch S2 SettingsLoading Stock Printer OperationWeb Guides Butt SpliceANTI-STATIC Gloves and the ANTI-STATIC Wrist Strap Print Head OperationPrint Head Open / Closed Installing Ink Ribbon Splices Printer Controls Control Panel OperationStart FeedTest Indicator LightsStop On LineSensor ErrorHome Screen Display ModesSetup Screen Verifier Setup Screen Power UP Diagnostics Home Screen Print / CUT Positions Printhead Setup Control Panel Operation Printhead Setup Feature Setup Screen Control Panel Operation Control Panel Operation Sensor Adjustments AdjustmentsFeed Roller Pressure SensorsMachine Set Up Sequence Cleaning MaintenancePrint Head Cleaning ProcedureClean Platen Roller Print Head HandlingHandling Print Head Replacement Remove the old printhead carefully from the heat sink Printhead Category Chart Composition Iglide Bearings Lubrication ProcedurePower Up / Sign On / Communications Electrical Trouble ShootingProblem Probable Cause Corrective Action Stock / Ink Advance Print Stock Mechanical Trouble ShootingInk Appendix a Error MessagesSoftware Upgrade Chip Placement Positions Appendix BThermal Control Board P/N 371105TT Head Driver Board Head Driver Board P/N 371106TTFront Panel Board P / N Front Panel Diagnostic DescriptionsAppendix C Printhead Life ExtensionMatching stock and ink widths Printhead Fail Modes Symptoms, Causes, SolutionsPrinthead Cleaning Procedure Machine Cleaning ProcedurePrinthead cleaning when removed from the printer Printhead Installation and Removal Procedures Printhead removal procedurePrinthead installation procedure Machine Wiring Electrical Assembly DrawingsElectrical System Schematic Motherboard Power Connectors Mechanical Assembly Drawings Unwind Assembly Drawing Unwind Parts List Web Guide Assembly Drawing Web Guide Parts List Drive Assembly Drawing Drive Parts List Top Printhead Assembly Drawing Top Printhead Parts List Bottom Printhead Assembly Drawing Bottom Printhead Parts List Ink Unwind / Rewind Assembly Drawing Ink Unwind / Rewind Parts List Web Tension Guide Assembly Drawing Web Tension Guide Parts List Drive Belt Routing Drawing Mechanical Assembly Drawings