Siemens E-110-I user manual Creating an EoA interface, Field Description VC Interface, Mux Type

SIEMENS ADSL E-110_E-110-I user manual

3.	Enter the provided fields as below.
	Field	Description
	VC Interface	Select a VCC interface from the available interfaces, e.g. aal5-1.
	VPI / VCI	Enter the VPI/VCI values given by your ISP, e.g. 0 / 33.
	Mux Type	Select LLC or VC as required by your ISP.
	Max Proto per AAL5	Keep the default 2.
4.	After entering the fields above, click [Apply].
5.	When confirmation page appears, click [Close].
6.	You will return to the ATM VC Configuration page and see the newly added ATM VC entry.

2. Creating an EoA interface.

1.Select Bridge > RFC1483 Interface (EoA).

2.On the ATM(EoA) Config page click [Add] to add a new EoA interface.

3.Enter the provided fields as below:

Field		Description
EOA Interface		Select an EoA interface from the available interfaces, e.g. eoa-1.
Interface Sec Type		Select Public.
Lower Interface		Select the ATM VCC interface you created, e.g. aal5-1.
Conf. IP Address /	0.0.0.0 / 0.0.0.0.
Netmask		To use the device as a bridge, you don’t need to set the IP address and
		subnet mask. Just keep the default.
Use DHCP		Select Disable
Default Route		Select Disable
Gateway IP Address		Leave it empty. You don’t need to set the gateway.

4.After entering the fields above, click [Apply].

72 Rev:01_040220