2. PRINTER SETUP | ENGLISH VERSION |
2.6 Loading the Media
2.6Loading the Media (Cont.)
NOTE:
When the media is correctly set, the backing paper is supposed to be pinched by the Platen and the Strip Feed Roller as shown below.
Strip Plate
Label
Strip Feed Roller
Platen
Backing Paper
WARNING!
1.When attaching or removing the cutter cover, be sure to turn off the power. Otherwise, you may be injured.
2.The cutter is sharp, so care must be taken not to injure yourself when handling the cutter.
CAUTION!
1.Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the cutter which may affect the cutter quality and shorten the cutter life.
2.Use of tag paper when the thickness exceeds the specified value may affect the cutter life.
Strip mode (Option):
When issued in the strip mode, labels are automatically removed from the backing paper each time a label is printed.
∙How to set the media
When issuing labels in the strip mode, set the label in the following procedure:
1.Open the Strip Block by the tabs on both sides.
Tab 
Strip Block
2.Remove enough labels from the leading edge of the media to leave about 200 mm of backing paper free.
3.Pass the backing paper over the Platen and the Strip Plate, and insert the leading edge of the backing paper into the Backing Paper Outlet.
Strip Feed Roller
Platen
Strip Plate
Strip Block
Backing Paper
Backing Paper Outlet
4.Close the Strip Block.
Cut mode:
When the Cutter is fitted, the media is automatically cut.
After loading the media as described on the previous pages, insert the leading edge of the media into the Media Outlet of the Cutter.
Media Outlet 
Cutter Cover
E2- 7