Toshiba B-SV4D-QM owner manual CE Compliance for EU only, Vorsicht

Page 2

CE Compliance (for EU only)

This product complies with the requirements of EMC and Low Voltage Directives including their amendments.

VORSICHT:

Schallemission: unter 70dB (A) nach DIN 45635 (oder ISO 7779)

Die für das Gerät Vorgesehene Steckdose muß in der Nähe des Gerätes und leicht zugänglich sein.

Centronics is a registered trademark of Centronics Data Computer Corp.

Microsoft is a registered trademark of Microsoft Corporation.

Windows is a trademark of Microsoft Corporation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

(for USA only)

Changes or modifications not expressly approved by manufacturer for compliance could void the user’s authority to operate the equipment.

“This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.”

“Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.”

(for CANADA only)

The EA10953 AC adapter should be exclusively used for the B-SV4D-QM Series printer. The B-SV4D-QM Series printer must be powered by the EA10953 AC adapter.

Copyright © 2003

by TOSHIBA TEC CORPORATION All Rights Reserved

570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN

Image 2
Contents SV4D-QM CE Compliance for EU only VorsichtWkhsoxj Wkhsoxj Table of Contents Product Overview Introduction FeaturesAccessories UnpackingWhen purchasing the power cord Front View Rear View DimensionsAppearance Button and Indicator Lamp InteriorPrinter Setup PrecautionsTurning on the Printer Procedure before OperationTurning the Printer Connecting the Cables to the Printer Turning OFF the PrinterConnecting the Power Adapter and the Power Cord Loading the Media Batch mode Cut mode Strip mode Option∙ How to set the media External Media Roll Hanger Option Media Sensor Test, and Dump Mode different type UtilitiesSelf Print Test and Dump Mode Media Sensor CalibrationPrint test label sample Print Head MaintenanceCleaning Platen/Sensors CoverCare/Handling of the Media Problems Solutions TroubleshootingTroubleshooting Guide Removing Jammed MediaA1.1 Printer Appendix 1 SpecificationsSpecifications A1.3.1 Media Type A1.2 OptionsA1.3 Media Option Name Type DescriptionA1.3.3 Detection Area of the Reflective Sensor Media TypeA1.3.2 Detection Area of the Transmissive Sensor A1.3.4 Effective Print Area Figure below shows the effective print area on the mediaAppendix 2 Interface „Interface CablesGlossaries Bar codeIndex LAN EA1-1Index EO1-33035