(3)Label End
c When the transmissive sensor and lower reflective sensor detect the label end state in 3 mm continuously, an error will result.
d If the transmissive sensor and lower reflective sensor detect the label end state when an issue, feed, and ejection are attempted in a printer stop state, an error will result.
(4)Head Open Error
cIf the head open sensor detects the open state in 5 mm continuously, an error will result.
dIf the head open sensor detects the open state when an issue, feed, and ejection are attempted in a printer stop state, an error will result.
However, the feeding by the [FEED] key on the printer and the issuing and feeding by the expansion I/O, are not included.
(5)Thermal Head Error
cA broken dot error has occurred in the thermal head. d An error has occurred in the thermal head driver.
(6)Thermal Head Excessive Temperature
cWhen the
dWhen the thermal head temperature detection thermistor detects an excessively high temperature, an error will result.
eWhen the heat sink sensor detects an excessively high temperature, an error will result.
fIn the direct thermal printing, if the thermal head temperature detection thermistor detects more than 65°C, the printer completes printing, then stops until the temperature becomes 65 °C or lower.
(7)Ribbon Error
When the ribbon is specified, and the motor speed calculated from the ribbon motor sensors (rewind/back tension) and rotation direction are out of specification, an error will result.
cRotation of the ribbon motor (rewind) is too fast.
eRotation of the ribbon motor (rewind) is too slow, or the ribbon motor does not rotate.
eThe ribbon motor (back tension) does not rotate.
fThe ribbon motor (back tension) rotates in the reverse direction.
•The ribbon is not installed.
•A ribbon jam has occurred.
•The ribbon has been torn.
•An abnormal condition has occurred in the ribbon motor sensor.
•The ribbon has run out.
*At the moment an error occurs, the printer displays the error message, makes a status response, then stops. Only the Status Request Command and Reset Command can be processed, and other commands are not processed. Restoration using the [RESTART] key is possible except in the case of a thermal head excessive temperature error. (The printer resumes printing the label where the error occurred.)
- 197 -