Notes
(1)Before changing the label size or type of sensor, the Label Size Set Command must first be transmitted.
(2)The Label Size Set Command is protected in memory (even if the power is turned off).
(3)After sending the Label Size Set Command, one sheet of paper must be fed by the Feed Command ([ESC] T) and must be aligned with the first print position prior to printing.
(4)The origin of drawing coordinates, print stop position (head position at stop), and cut position are determined according to the parameters of the Label Size Set Command as shown in the figure on the preceding page. For the print stop position in the strip issue mode for the auto labeler, refer to the section of the Position Fine Adjust Command. The effective print area is centered on the label/tag.
(5)Printing cannot be performed in the slow up (1 mm) and slow down (1 mm) areas. Consequently, [A : Label/tag pitch] - [H: Effective print length] ≥ 2 mm must be assumed.
(6)The origin of drawing coordinates, print stop position (head position at stop), and cut position are adjustable by the fine adjust commands and according to the fine adjustment settings in the system mode.
(7)The tag rotation designation of the Issue Command ([ESC] XS) causes the origin of drawing coordinates to be origin c in the case of “printing bottom first” and to be origin d in the case of “printing top first”, as shown in the figure on the preceding page.
(8)The parameters must be as shown in the figure and table. Any value or paper outside the range results in a failure of printing or an error.
(9)Where an effective print length within “max. effective print length for
However, printing may stop every label depending on the quantity of drawing data.
- 34 -